On 2/24/2016 3:41 AM, Lyude wrote:
As it turns out, resuming DP MST is racey since we don't make sure MST
is ready before we start modesetting, it just usually happens to be
ready in time. This isn't the case on all systems, particularly a
ThinkPad T560 with displays connected through the dock. On these
systems, resuming the laptop while connected to the dock usually results
in blank monitors. Making sure MST is ready before doing any kind of
modesetting fixes this issue.
basic question since i haven't worked on MST much. MST should work like any
other digital panel on resume. i.e detect followed by modeset. in the
modified
commit mentioned below is it failing to detect the panel or failing at
the modeset ?
if we are depending on the intel_display_resume, how about moving the
intel_dp_mst_resume just above intel_display_resume?
Generic question to others in mail list on i915_drm_resume
we are doing a modeset and then doing the detect/hpd init.
shouldn't this be the other way round ? almost all displays
will pass a modeset even if display is not connected so we
are spending time on modeset even for displays that were
removed during the suspend state. if this is to simply
drm_state being saved and restored,
We originally changed the resume order in
commit e7d6f7d70829 ("drm/i915: resume MST after reading back hw state")
to fix a ton of WARN_ON's after resume, but this doesn't seem to be an
issue now anyhow.
CC: stable@xxxxxxxxxxxxxxx
Signed-off-by: Lyude <cpaul@xxxxxxxxxx>
---
drivers/gpu/drm/i915/i915_drv.c | 10 ++++++++--
1 file changed, 8 insertions(+), 2 deletions(-)
diff --git a/drivers/gpu/drm/i915/i915_drv.c b/drivers/gpu/drm/i915/i915_drv.c
index f357058..4dcf3dd 100644
--- a/drivers/gpu/drm/i915/i915_drv.c
+++ b/drivers/gpu/drm/i915/i915_drv.c
@@ -733,6 +733,14 @@ static int i915_drm_resume(struct drm_device *dev)
intel_opregion_setup(dev);
intel_init_pch_refclk(dev);
+
+ /*
+ * We need to make sure that we resume MST before doing anything
+ * display related, otherwise we risk trying to bring up a display on
+ * MST before the hub is actually ready
+ */
+ intel_dp_mst_resume(dev);
+
This does not look proper. if the CD clock is turned off during suspend
our dpcd read itself might fail till we enable CD Clock.
regards,
Sivakumar
drm_mode_config_reset(dev);
/*
@@ -765,8 +773,6 @@ static int i915_drm_resume(struct drm_device *dev)
intel_display_resume(dev);
drm_modeset_unlock_all(dev);
- intel_dp_mst_resume(dev);
-
/*
* ... but also need to make sure that hotplug processing
* doesn't cause havoc. Like in the driver load code we don't
_______________________________________________
dri-devel mailing list
dri-devel@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/dri-devel
