On Thu, 16 Dec 2010 18:30:11 +0100, Domenico Andreoli <cavokz@xxxxxxxxx> wrote: > Hi, > > On Wed, Dec 15, 2010 at 07:10:28PM -0800, ext Linus Torvalds wrote: > > > > Go forth and test. And please do remember to ping bugzilla (or > > developers) about any regressions you find, whether new or old. > > I have some problem with i945, display remains blank. I also tried > adding i915.modeset=0 but nothing changed. Machine is well alive and > responds to basic commands like Ctrl+Alt+F1 and Ctrl+Alt+Del but I have > not other machine to enter via network. If i915.modeset=0 doesn't restore the display then something is extremely fishy. Do you see any console output before the i915.ko is loaded? > [ 1.284262] [drm] Initialized drm 1.1.0 20060810 > [ 1.284334] i915 0000:00:02.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16 > [ 1.485212] vgaarb: device changed decodes: PCI:0000:00:02.0,olddecodes=io+mem,decodes=io+mem:owns=io+mem > [ 1.485642] [drm] initialized overlay support > [ 2.526011] No connectors reported connected with modes > [ 2.526053] [drm] Cannot find any crtc or sizes - going 1024x768 The issue appears to be that no outputs are being detected. I presume that you have instead a VGA connected to the box and that the regression is in fact e7dbb2f2. If I'm guessing rightly: diff --git a/drivers/gpu/drm/i915/intel_crt.c b/drivers/gpu/drm/i915/intel_crt.c index 8df5743..14c276e 100644 --- a/drivers/gpu/drm/i915/intel_crt.c +++ b/drivers/gpu/drm/i915/intel_crt.c @@ -148,7 +148,9 @@ static void intel_crt_mode_set(struct drm_encoder *encoder, dpll_md & ~DPLL_MD_UDI_MULTIPLIER_MASK); } - adpa = ADPA_HOTPLUG_BITS; + adpa = 0; + if (INTEL_INFO(dev)->gen >= 4) + adpa |= ADPA_HOTPLUG_BITS; if (adjusted_mode->flags & DRM_MODE_FLAG_PHSYNC) adpa |= ADPA_HSYNC_ACTIVE_HIGH; if (adjusted_mode->flags & DRM_MODE_FLAG_PVSYNC) -- Chris Wilson, Intel Open Source Technology Centre _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx http://lists.freedesktop.org/mailman/listinfo/dri-devel