The current logic is enabling both STOP_INT_MASK and ABORT_INT_MASK bit. This is apparently masking those particular interrupt rather than unmasking the same. This change will reset STOP_INT_MASK and ABORT_INT_MASK bit and unmask these interrupts. Signed-off-by: Mrinmay Sarkar <quic_msarkar@xxxxxxxxxxx> --- drivers/dma/dw-edma/dw-hdma-v0-core.c | 9 +++++---- 1 file changed, 5 insertions(+), 4 deletions(-) diff --git a/drivers/dma/dw-edma/dw-hdma-v0-core.c b/drivers/dma/dw-edma/dw-hdma-v0-core.c index 10e8f07..88bd652f 100644 --- a/drivers/dma/dw-edma/dw-hdma-v0-core.c +++ b/drivers/dma/dw-edma/dw-hdma-v0-core.c @@ -247,10 +247,11 @@ static void dw_hdma_v0_core_start(struct dw_edma_chunk *chunk, bool first) if (first) { /* Enable engine */ SET_CH_32(dw, chan->dir, chan->id, ch_en, BIT(0)); - /* Interrupt enable&unmask - done, abort */ - tmp = GET_CH_32(dw, chan->dir, chan->id, int_setup) | - HDMA_V0_STOP_INT_MASK | HDMA_V0_ABORT_INT_MASK | - HDMA_V0_LOCAL_STOP_INT_EN | HDMA_V0_LOCAL_ABORT_INT_EN; + /* Interrupt unmask - done, abort */ + tmp = GET_CH_32(dw, chan->dir, chan->id, int_setup) & + ~HDMA_V0_STOP_INT_MASK & ~HDMA_V0_ABORT_INT_MASK; + /* Interrupt enable - done, abort */ + tmp |= HDMA_V0_LOCAL_STOP_INT_EN | HDMA_V0_LOCAL_ABORT_INT_EN; if (!(dw->chip->flags & DW_EDMA_CHIP_LOCAL)) tmp |= HDMA_V0_REMOTE_STOP_INT_EN | HDMA_V0_REMOTE_ABORT_INT_EN; SET_CH_32(dw, chan->dir, chan->id, int_setup, tmp); -- 2.7.4