On 14/11/2023 10:39, Siddharth Vadapalli wrote: > The existing APIs for requesting TX and RX DMA channels rely on parsing > a device-tree node to obtain the Channel/Thread IDs from their names. Yes, since it is a DMA device and it is using the standard DMA mapping. It is by design that the standard DMAengine and the custom glue layer (which should have been a temporary solution) uses the same standard DMA binding to make sure that we are not going to deviate from the standard and be able to move the glue users to DMAengine (which would need core changes). > However, it is possible to know the thread IDs by alternative means such > as being informed by Firmware on a remote core regarding the allocated > TX/RX DMA channel IDs. Thus, add APIs to support such use cases. I see, so the TISCI res manager is going to managed the channels/flows for some peripherals? What is the API and parameters to get these channels? I would really like to follow a standard binding since what will happen if the firmware will start to provision channels/flows for DMAengine users? It is not that simple to hack that around. My initial take is that this can be implemented via the existing DMA crossbar support. It has been created exactly for this sort of purpose. I'm sure you need to provide some sort of parameters to TISCI to get the channel/rflow provisioned for the host requesting, right? The crossbar implements the binding with the given set of parameters, does the needed 'black magic' to get the information needed for the target DMA and crafts the binding for it and get's the channel. If you take a look at the drivers/dma/ti/dma-crossbar.c, it implements two types of crossbars. For DMAengine, it would be relatively simple to write a new one for tisci, The glue layer might needs a bit more work as it is not relying on core, but I would not think that it is that much complicated to extend it to be able to handle a crossbar binding. The benefit is that none of the clients should not need to know about the way the channel is looked up, they just request for an RX channel and depending on the binding they will get it directly from the DMA or get the translation via the crossbar to be able to fetch the channel. Can you check if this would be doable? For reference: Documentation/devicetree/bindings/dma/dma-router.yaml Documentation/devicetree/bindings/dma/ti-dma-crossbar.txt drivers/dma/ti/dma-crossbar.c > Additionally, since the name of the device for the remote RX channel is > being set purely on the basis of the RX channel ID itself, it can result > in duplicate names when multiple flows are used on the same channel. > Avoid name duplication by including the flow in the name. Make sense. > Series is based on linux-next tagged next-20231114. > > RFC Series: > https://lore.kernel.org/r/20231111121555.2656760-1-s-vadapalli@xxxxxx/ > > Changes since RFC Series: > - Rebased patches 1, 2 and 3 on linux-next tagged next-20231114. > - Added patch 4 to the series. > > Regards, > Siddharth. > > Siddharth Vadapalli (4): > dmaengine: ti: k3-udma-glue: Add function to parse channel by ID > dmaengine: ti: k3-udma-glue: Add function to request TX channel by ID > dmaengine: ti: k3-udma-glue: Add function to request RX channel by ID > dmaengine: ti: k3-udma-glue: Update name for remote RX channel device > > drivers/dma/ti/k3-udma-glue.c | 306 ++++++++++++++++++++++--------- > include/linux/dma/k3-udma-glue.h | 8 + > 2 files changed, 228 insertions(+), 86 deletions(-) > -- Péter
