Re: [PATCH v4 2/3] dmaengine: add peripheral configuration

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




On 09/10/2020 14.15, Vinod Koul wrote:
>>> If for any any reason subsequent txn is for different direction, I would
>>> expect that parameters are set again before prep_ calls
>>
>> But in DEV_TO_DEV?
> 
> Do we support that :D
> 
>> If we have two peripherals, both needs config:
>> p1_config and p2_config
>>
>> What and how would one use the single peripheral_config?
> 
> Since the config is implementation specific, I do not think it limits.
> You may create
> 
> struct peter_config {
>         struct p1_config;
>         struct p2_config;
> };

The use case is:
MEM -DMA-> P1 -DMA-> P2
or
P2 -DMA-> P1 -DMA-> MEM
or
MEM -DMA-> P2
or
P2 -DMA-> MEM
or
MEM -DMA-> P1 -DMA-> MEM

How would the DMA guess what it should do? How would the independent P1
and P2 would know how to set up the config?

>>
>> If only one of them needs config, then sure, the driver can pin-point
>> which one the single config might apply to.
>>
>> Or you chain the same type of peripheral and you would need different
>> config for tx and rx?
>>
>> - Péter
>>
>> Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki.
>> Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki
> 

- Péter

Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki.
Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki



[Index of Archives]     [Linux Kernel]     [Linux ARM (vger)]     [Linux ARM MSM]     [Linux Omap]     [Linux Arm]     [Linux Tegra]     [Fedora ARM]     [Linux for Samsung SOC]     [eCos]     [Linux PCI]     [Linux Fastboot]     [Gcc Help]     [Git]     [DCCP]     [IETF Announce]     [Security]     [Linux MIPS]     [Yosemite Campsites]

  Powered by Linux