Hi, As I have mentioned on the symlink patch earlier I like how the gpio's debugfs shows in one place information. These patches are on top of Vinod's next (with the v2 fix for the symlink support). The first patch fixes and cleans up the symlink handling code a bit and the second adds support for debugfs file: On my board with audio and after a run with dmatest on 6 channels this is how the information is presented about the DMA drivers: # cat /sys/kernel/debug/dmaengine dma0 (285c0000.dma-controller): number of channels: 96 dma1 (31150000.dma-controller): number of channels: 267 dma1chan0: 2b00000.mcasp:tx dma1chan1: 2b00000.mcasp:rx dma1chan2: in-use dma1chan3: in-use dma1chan4: in-use dma1chan5: in-use dma1chan6: in-use dma1chan7: in-use It shows the users (device name + channel name) of the channels. If it is not a slave channel, then it only prints 'in-use' as no other information is available for non save channels. DMA drivers can implement the dbg_show callback to provide custom information for their channels if needed. Regards, Peter --- Peter Ujfalusi (2): dmaengine: Cleanups for the slave <-> channel symlink support dmaengine: Add basic debugfs support drivers/dma/dmaengine.c | 143 +++++++++++++++++++++++++++++++++++--- include/linux/dmaengine.h | 12 +++- 2 files changed, 144 insertions(+), 11 deletions(-) -- Peter Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki. Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki
