On Sun, Nov 06, 2016 at 09:31:17PM +0000, Peter Robinson wrote: > There's not much point in enabling SoC specific DMA drivers for > platform drivers unless their actual SoC is enabled. They're not > useful without it. Yes but it enables compile on other platforms. I would very much refer to get more builds on these rather than not being able to build.. > > Signed-off-by: Peter Robinson <pbrobinson@xxxxxxxxx> > --- > drivers/dma/Kconfig | 13 +++++++------ > 1 file changed, 7 insertions(+), 6 deletions(-) > > diff --git a/drivers/dma/Kconfig b/drivers/dma/Kconfig > index af63a6b..6c758c8 100644 > --- a/drivers/dma/Kconfig > +++ b/drivers/dma/Kconfig > @@ -184,7 +184,7 @@ config FSL_DMA > > config FSL_EDMA > tristate "Freescale eDMA engine support" > - depends on OF > + depends on OF && FSL_SOC > select DMA_ENGINE > select DMA_VIRTUAL_CHANNELS > help > @@ -230,6 +230,7 @@ config IMX_SDMA > > config INTEL_IDMA64 > tristate "Intel integrated DMA 64-bit support" > + depends on X86 > select DMA_ENGINE > select DMA_VIRTUAL_CHANNELS > help > @@ -339,7 +340,7 @@ config MV_XOR > > config MV_XOR_V2 > bool "Marvell XOR engine version 2 support " > - depends on ARM64 > + depends on ARM64 && ARCH_MVEBU > select DMA_ENGINE > select DMA_ENGINE_RAID > select ASYNC_TX_ENABLE_CHANNEL_SWITCH > @@ -383,7 +384,7 @@ config MX3_IPU_IRQS > config NBPFAXI_DMA > tristate "Renesas Type-AXI NBPF DMA support" > select DMA_ENGINE > - depends on ARM || COMPILE_TEST > + depends on (ARM && ARCH_SHMOBILE) || COMPILE_TEST > help > Support for "Type-AXI" NBPF DMA IPs from Renesas > > @@ -493,7 +494,7 @@ config TEGRA210_ADMA > > config TIMB_DMA > tristate "Timberdale FPGA DMA support" > - depends on MFD_TIMBERDALE || COMPILE_TEST > + depends on MFD_TIMBERDALE && (CONFIG_X86_32 || COMPILE_TEST) > select DMA_ENGINE > help > Enable support for the Timberdale FPGA DMA engine. > @@ -531,7 +532,7 @@ config XGENE_DMA > > config XILINX_DMA > tristate "Xilinx AXI DMAS Engine" > - depends on (ARCH_ZYNQ || MICROBLAZE || ARM64) > + depends on (ARCH_ZYNQ || ARCH_ZYNQMP || MICROBLAZE) > select DMA_ENGINE > help > Enable support for Xilinx AXI VDMA Soft IP. > @@ -550,7 +551,7 @@ config XILINX_DMA > > config XILINX_ZYNQMP_DMA > tristate "Xilinx ZynqMP DMA Engine" > - depends on (ARCH_ZYNQ || MICROBLAZE || ARM64) > + depends on (ARCH_ZYNQ || ARCH_ZYNQMP || MICROBLAZE) > select DMA_ENGINE > help > Enable support for Xilinx ZynqMP DMA controller. > -- > 2.9.3 > -- ~Vinod -- To unsubscribe from this list: send the line "unsubscribe dmaengine" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
