Re: [PATCH V2] dmaengine: imx-sdma: Add device to device support

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Fri, Jul 10, 2015 at 03:58:36PM +0800, Shengjiu Wang wrote:
> On Fri, Jul 10, 2015 at 01:28:07PM +0530, Vinod Koul wrote:
> > On Tue, Jul 07, 2015 at 05:20:04PM +0800, Shengjiu Wang wrote:
> > 
> > > +/*
> > > + *  p_2_p watermark_level description
> > > + *	Bits		Name			Description
> > > + *	0-7		Lower WML		Lower watermark level
> > > + *	8		PS			1: Pad Swallowing
> > > + *						0: No Pad Swallowing
> > > + *	9		PA			1: Pad Adding
> > > + *						0: No Pad Adding
> > > + * 	10		SPDIF			If this bit is set both source
> > > + *						and destination are on SPBA
> > > + *	11		Source Bit(SP)		1: Source on SPBA
> > > + *						0: Source on AIPS
> > > + *	12		Destination Bit(DP)	1: Destination on SPBA
> > > + *						0: Destination on AIPS
> > > + *	13-15		---------		MUST BE 0
> > > + *	16-23		Higher WML		HWML
> > > + *	24-27		N			Total number of samples after
> > > + *						which Pad adding/Swallowing
> > > + *						must be done. It must be odd.
> > > + *	28		Lower WML Event(LWE)	SDMA events reg to check for
> > > + *						LWML event mask
> > > + *						0: LWE in EVENTS register
> > > + *						1: LWE in EVENTS2 register
> > > + *	29		Higher WML Event(HWE)	SDMA events reg to check for
> > > + *						HWML event mask
> > > + *						0: HWE in EVENTS register
> > > + *						1: HWE in EVENTS2 register
> > > + *	30		---------		MUST BE 0
> > > + *	31		CONT			1: Amount of samples to be
> > > + *						transferred is unknown and
> > > + *						script will keep on
> > > + *						transferring samples as long as
> > > + *						both events are detected and
> > > + *						script must be manually stopped
> > > + *						by the application
> > > + *						0: The amount of samples to be
> > > + *						transferred is equal to the
> > > + *						count field of mode word
> > > + */
> > > +static void sdma_set_watermarklevel_for_p2p(struct sdma_channel *sdmac)
> > > +{
> > > +	struct sdma_engine *sdma = sdmac->sdma;
> > > +
> > > +	int lwml = sdmac->watermark_level & 0xff;
> > > +	int hwml = (sdmac->watermark_level >> 16) & 0xff;
> > > +
> > > +	__set_bit(sdmac->event_id0 % 32, &sdmac->event_mask[1]);
> > > +	__set_bit(sdmac->event_id1 % 32, &sdmac->event_mask[0]);
> > > +
> > > +	if (sdmac->event_id0 > 31)
> > > +		__set_bit(28, &sdmac->watermark_level);
> > > +
> > > +	if (sdmac->event_id1 > 31)
> > > +		__set_bit(29, &sdmac->watermark_level);
> > > +
> > > +	/*
> > > +	 * If LWML(src_maxburst) > HWML(dst_maxburst), we need
> > > +	 * swap LWML and HWML of INFO(A.3.2.5.1), also need swap
> > > +	 * r0(event_mask[1]) and r1(event_mask[0]).
> > > +	 */
> > > +	if (lwml > hwml) {
> > > +		sdmac->watermark_level &= ~0xff00ff;
> > > +		sdmac->watermark_level |= hwml;
> > > +		sdmac->watermark_level |= lwml << 16;
> > > +		swap(sdmac->event_mask[0], sdmac->event_mask[1]);
> > so typical practice is to define macros for these. For example above can be
> > defined as
> > #define SDMA_WATERMARK_LWML BIT(X)
> > #define SDMA_WATERMARK_PA BIT(Y)
> > 
> > Then here you can say
> > 	sdmac->watermark_level &= SDMA_WATERMARK_PA | ....
> > 
> > That way it is easier to read, review and maintain
> > 
> > 
> > > +	}
> > > +
> > > +	if (sdmac->per_address2 >= sdma->spba_start_addr &&
> > > +			sdmac->per_address2 <= sdma->spba_end_addr)
> > > +		__set_bit(11, &sdmac->watermark_level);
> > > +
> > > +	if (sdmac->per_address >= sdma->spba_start_addr &&
> > > +			sdmac->per_address <= sdma->spba_end_addr)
> > > +		__set_bit(12, &sdmac->watermark_level);
> > > +
> > > +	__set_bit(31, &sdmac->watermark_level);
> > All these and few more below will look much better by have defines above
> > 
> > > @@ -1221,6 +1311,14 @@ static int sdma_config(struct dma_chan *chan,
> > >  		sdmac->watermark_level = dmaengine_cfg->src_maxburst *
> > >  			dmaengine_cfg->src_addr_width;
> > >  		sdmac->word_size = dmaengine_cfg->src_addr_width;
> > > +	} else if (dmaengine_cfg->direction == DMA_DEV_TO_DEV) {
> > > +		sdmac->per_address2 = dmaengine_cfg->src_addr;
> > > +		sdmac->per_address = dmaengine_cfg->dst_addr;
> > > +		sdmac->watermark_level =
> > > +			dmaengine_cfg->src_maxburst & 0xff;
> > > +		sdmac->watermark_level |=
> > > +			(dmaengine_cfg->dst_maxburst & 0xff) << 16;
> > > +		sdmac->word_size = dmaengine_cfg->dst_addr_width;
> > Please fix this as well
> >
> I will refine this patch and send V3 for review. Thanks 
> 
> best regards
> wang shengjiu
> > -- 
> > ~Vinod

Hi Vinod
    V3 for this patch has been sent, please review. Thanks.

Best regards
Wang Shengjiu
--
To unsubscribe from this list: send the line "unsubscribe dmaengine" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Linux Kernel]     [Linux ARM (vger)]     [Linux ARM MSM]     [Linux Omap]     [Linux Arm]     [Linux Tegra]     [Fedora ARM]     [Linux for Samsung SOC]     [eCos]     [Linux PCI]     [Linux Fastboot]     [Gcc Help]     [Git]     [DCCP]     [IETF Announce]     [Security]     [Linux MIPS]     [Yosemite Campsites]

  Powered by Linux