This patch removes the crci information from the dma channel property. At least one client device requires using more than one CRCI value for a channel. This does not match the current binding and the crci information needs to be removed. Instead, the client device will provide this information via other means. Signed-off-by: Andy Gross <agross@xxxxxxxxxxxxxx> --- Documentation/devicetree/bindings/dma/qcom_adm.txt | 14 +++++--------- 1 file changed, 5 insertions(+), 9 deletions(-) diff --git a/Documentation/devicetree/bindings/dma/qcom_adm.txt b/Documentation/devicetree/bindings/dma/qcom_adm.txt index 9bcab91..fba67c6 100644 --- a/Documentation/devicetree/bindings/dma/qcom_adm.txt +++ b/Documentation/devicetree/bindings/dma/qcom_adm.txt @@ -4,8 +4,7 @@ Required properties: - compatible: must contain "qcom,adm" for IPQ/APQ8064 and MSM8960 - reg: Address range for DMA registers - interrupts: Should contain one interrupt shared by all channels -- #dma-cells: must be <2>. First cell denotes the channel number. Second cell - denotes CRCI (client rate control interface) flow control assignment. +- #dma-cells: must be <1>. First cell denotes the channel number. - clocks: Should contain the core clock and interface clock. - clock-names: Must contain "core" for the core clock and "iface" for the interface clock. @@ -22,7 +21,7 @@ Example: compatible = "qcom,adm"; reg = <0x18300000 0x100000>; interrupts = <0 170 0>; - #dma-cells = <2>; + #dma-cells = <1>; clocks = <&gcc ADM0_CLK>, <&gcc ADM0_PBUS_CLK>; clock-names = "core", "iface"; @@ -35,15 +34,12 @@ Example: qcom,ee = <0>; }; -DMA clients must use the format descripted in the dma.txt file, using a three +DMA clients must use the format descripted in the dma.txt file, using a two cell specifier for each channel. Each dmas request consists of 3 cells: 1. phandle pointing to the DMA controller 2. channel number - 3. CRCI assignment, if applicable. If no CRCI flow control is required, use 0. - The CRCI is used for flow control. It identifies the peripheral device that - is the source/destination for the transferred data. Example: @@ -56,7 +52,7 @@ Example: cs-gpios = <&qcom_pinmux 20 0>; - dmas = <&adm_dma 6 9>, - <&adm_dma 5 10>; + dmas = <&adm_dma 6>, + <&adm_dma 5>; dma-names = "rx", "tx"; }; -- The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, hosted by The Linux Foundation -- To unsubscribe from this list: send the line "unsubscribe dmaengine" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
