From: Nitin Yewale <nyewale@xxxxxxxxxx> Move "multipathd show wildcards" command above the $format commands and also add $format options for "map" and "path" commands to the multipathd man page. Signed-off-by: Benjamin Marzinski <bmarzins@xxxxxxxxxx> --- multipathd/multipathd.8 | 16 ++++++++++++---- 1 file changed, 12 insertions(+), 4 deletions(-) diff --git a/multipathd/multipathd.8 b/multipathd/multipathd.8 index bdf102eb..95d475da 100644 --- a/multipathd/multipathd.8 +++ b/multipathd/multipathd.8 @@ -113,9 +113,17 @@ The following commands can be used in interactive mode: Show the paths that multipathd is monitoring, and their state. . .TP +.B list|show wildcards +Show the format wildcards used in interactive commands taking $format. +. +.TP .B list|show paths format $format Show the paths that multipathd is monitoring, using a format string with path format wildcards. + +path format wildcards: + +%w (uuid), %i (hcil), %d (dev), %D (dev_t), %t (dm_st), %o (dev_st), %T (chk_st), %s (vend/prod/rev), %c (checker), %C (next_check), %p (pri), %S (size), %z (serial), %M (marginal_st), %m (multipath), %N (host WWNN), %n (target WWNN), %R (host WWPN), %r (target WWPN), %a (host adapter), %G (foreign), %g (vpd page data), %0 (failures), %P (protocol) . .TP .B list|show maps|multipaths @@ -125,6 +133,10 @@ Show the multipath devices that the multipathd is monitoring. .B list|show maps|multipaths format $format Show the status of all multipath devices that the multipathd is monitoring, using a format string with multipath format wildcards. + +multipath format wildcards: + +%n (name), %w (uuid), %d (sysfs), %F (failback), %Q (queueing), %N (no. of paths), %r (write_prot), %t (dm-st), %S (size), %f (features), %x (failures), %h (hwhandler), %A (action), %0 (path_faults), %1 (switch_grp), %2 (map_loads), %3 (total_q_time), %4 (q_timeouts), %s (vend/prod/rev), %v (vend), %p (prod), %e (rev), %G (foreign), %g (vpd page data) . .TP .B list|show maps|multipaths status @@ -148,10 +160,6 @@ Show topology of a single multipath device specified by $map, for example 36005076303ffc56200000000000010aa. This map could be obtained from '\fIlist maps\fR'. . .TP -.B list|show wildcards -Show the format wildcards used in interactive commands taking $format. -. -.TP .B list|show config Show the currently used configuration, derived from default values and values specified within the configuration file \fI/etc/multipath.conf\fR. -- 2.17.2 -- dm-devel mailing list dm-devel@xxxxxxxxxx https://listman.redhat.com/mailman/listinfo/dm-devel
