If the partition information has changed on multipath devices (say, because it was updated on another node that has access to the same storage), users expect that running "multipathd reconfigure" will update that. However, if the checkers for the multipath device are pending for too long when the the device is reconfigured, multipathd will give up waiting for them, and refuse to reload the device, since there are no active paths. This means that no kpartx update will be triggered. Multipath is fully capable of reloading a multipath device that has no active paths. This has been possible for years. If multipath is supposed to reload the device, it should do so, even if there are no active paths. Generally, when multipath is force reloaded, kpartx will be updated. However when a device is reloaded with no paths, the udev rules won't run kpartx. But they also weren't running kpartx when the first valid path appeared, even though the dm activation rules get run in this case. This changes 11-dm-mpath.rules to run kpartx when a device goes from no usable paths to having usable paths. Signed-off-by: Benjamin Marzinski <bmarzins@xxxxxxxxxx> --- libmultipath/configure.c | 6 ------ multipath/11-dm-mpath.rules | 2 +- 2 files changed, 1 insertion(+), 7 deletions(-) diff --git a/libmultipath/configure.c b/libmultipath/configure.c index c95848a0..96c79610 100644 --- a/libmultipath/configure.c +++ b/libmultipath/configure.c @@ -710,12 +710,6 @@ select_action (struct multipath * mpp, vector curmp, int force_reload) return; } - if (pathcount(mpp, PATH_UP) == 0) { - mpp->action = ACT_IMPOSSIBLE; - condlog(3, "%s: set ACT_IMPOSSIBLE (no usable path)", - mpp->alias); - return; - } if (force_reload) { mpp->force_udev_reload = 1; mpp->action = ACT_RELOAD; diff --git a/multipath/11-dm-mpath.rules b/multipath/11-dm-mpath.rules index 07320a14..cd522e8c 100644 --- a/multipath/11-dm-mpath.rules +++ b/multipath/11-dm-mpath.rules @@ -75,7 +75,7 @@ ENV{MPATH_DEVICE_READY}=="0", ENV{DM_UDEV_DISABLE_OTHER_RULES_FLAG}="1" ENV{MPATH_DEVICE_READY}!="0", ENV{.MPATH_DEVICE_READY_OLD}=="0",\ ENV{DM_UDEV_DISABLE_OTHER_RULES_FLAG}="$env{DM_DISABLE_OTHER_RULES_FLAG_OLD}",\ ENV{DM_DISABLE_OTHER_RULES_FLAG_OLD}="",\ - ENV{DM_ACTIVATION}="1" + ENV{DM_ACTIVATION}="1", ENV{MPATH_UNCHANGED}="0" # The code to check multipath state ends here. We need to set # properties and symlinks regardless whether the map is usable or -- 2.17.2 -- dm-devel mailing list dm-devel@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/dm-devel