On Tue, Jan 30, 2018 at 6:14 AM, Mike Snitzer <snitzer@xxxxxxxxxx> wrote: > On Mon, Jan 29 2018 at 4:51pm -0500, > Bart Van Assche <Bart.VanAssche@xxxxxxx> wrote: > >> On Mon, 2018-01-29 at 16:44 -0500, Mike Snitzer wrote: >> > But regardless of which wins the race, the queue will have been run. >> > Which is all we care about right? >> >> Running the queue is not sufficient. With this patch applied it can happen >> that the block driver returns BLK_STS_DEV_RESOURCE, that the two or more >> concurrent queue runs finish before sufficient device resources are available >> to execute the request and that blk_mq_delay_run_hw_queue() does not get >> called at all. If no other activity triggers a queue run, e.g. request >> completion, this will result in a queue stall. > > If BLK_STS_DEV_RESOURCE is returned then the driver doesn't need to rely > on a future queue run. IIUC, that is the entire premise of > BLK_STS_DEV_RESOURCE. If the driver had doubt about whether the > resource were going to be available in the future it should return > BLK_STS_RESOURCE. > > That may seem like putting a lot on a driver developer (to decide > between the 2) but I'll again defer to Jens here. This was the approach > he was advocating be pursued. Thinking of further, maybe you can add the following description in V5, and it should be much easier for driver developer to follow: When any resource allocation fails, if driver can make sure that there is any in-flight IO, it is safe to return BLK_STS_DEV_RESOURCE to blk-mq, that is exactly what scsi_queue_rq() is doing. Follows the theory: 1) driver returns BLK_STS_DEV_RESOURCE if driver figures out there is any in-flight IO, in case of any resource allocation failure 2) If all these in-flight IOs complete before examining SCHED_RESTART in blk_mq_dispatch_rq_list(), SCHED_RESTART must be cleared, so queue is run immediately in this case by blk_mq_dispatch_rq_list(); 3) if there is any in-flight IO after/when examining SCHED_RESTART in blk_mq_dispatch_rq_list(): - if SCHED_RESTART isn't set, queue is run immediately as handled in 2) - otherwise, this request will be dispatched after any in-flight IO is completed via blk_mq_sched_restart() since this request is added to hctx->dispatch already And there are two invariants when driver returns BLK_STS_DEV_RESOURCE iff there is any in-flight IOs: 1) SCHED_RESTART must be zero if no in-flight IOs 2) there has to be any IO in-flight if SCHED_RESTART is read as 1 Thanks, Ming -- dm-devel mailing list dm-devel@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/dm-devel
