RDAC(Redundant Dual Active Controller) done by LSI/Engenio/NetApp are NetApp E-Series/F-Series and OEM arrays from IBM DELL SGI STK and SUN. Cc: Sean Stewart <sean.stewart@xxxxxxxxxx> Cc: Christophe Varoqui <christophe.varoqui@xxxxxxxxxxx> Cc: device-mapper development <dm-devel@xxxxxxxxxx> Signed-off-by: Xose Vazquez Perez <xose.vazquez@xxxxxxxxx> --- multipath/multipath.conf.5 | 9 ++++++--- 1 file changed, 6 insertions(+), 3 deletions(-) diff --git a/multipath/multipath.conf.5 b/multipath/multipath.conf.5 index 33f7df8..a59e7a1 100644 --- a/multipath/multipath.conf.5 +++ b/multipath/multipath.conf.5 @@ -224,7 +224,8 @@ accepts the optional prio_arg Generate the path priority for NetApp ONTAP class and OEM arrays as IBM NSeries. .TP .I rdac -Generate the path priority for LSI/Engenio/NetApp E-Series RDAC controller. +Generate the path priority for LSI/Engenio/NetApp RDAC class as NetApp E/EF +Series, and OEM arrays from IBM DELL SGI STK and SUN. .TP .I hp_sw Generate the path priority for Compaq/HP controller in @@ -313,7 +314,8 @@ for CLARiiON CX/AX and EMC VNX arrays families. Check the path state for HP storage arrays with Active/Standby firmware. .TP .I rdac -Check the path state for LSI/Engenio/NetApp E-Series RDAC storage controller. +Check the path state for LSI/Engenio/NetApp RDAC class as NetApp E/EF +Series, and OEM arrays from IBM DELL SGI STK and SUN. .TP .I directio (Deprecated) Read the first sector with direct I/O. This checker is being @@ -812,7 +814,8 @@ The following hardware handler are implemented: Hardware handler for DGC class arrays as CLARiiON CX/AX and EMC VNX families. .TP .I 1 rdac -Hardware handler for LSI/Engenio/NetApp E-Series RDAC storage controller. +Hardware handler for LSI/Engenio/NetApp RDAC class as NetApp E/EF +Series, and OEM arrays from IBM DELL SGI STK and SUN. .TP .I 1 hp_sw Hardware handler for Compaq/HP storage arrays in active/standby -- 2.7.4 -- dm-devel mailing list dm-devel@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/dm-devel
