On Wed, May 27, 2015 at 04:42:44PM -0700, Ming Lin wrote: > Here are fio results of XFS on a DM stripped target with 2 SSDs + 1 HDD. > Does it make sense? To stripe across devices with different characteristics? Some suggestions. Prepare 3 kernels. O - Old kernel. M - Old kernel with merge_bvec_fn disabled. N - New kernel. You're trying to search for counter-examples to the hypothesis that "Kernel N always outperforms Kernel O". Then if you find any, trying to show either that the performance impediment is small enough that it doesn't matter or that the cases are sufficiently rare or obscure that they may be ignored because of the greater benefits of N in much more common cases. (1) You're looking to set up configurations where kernel O performs noticeably better than M. Then you're comparing the performance of O and N in those situations. (2) You're looking at other sensible configurations where O and M have similar performance, and comparing that with the performance of N. In each case you find, you expect to be able to vary some parameter (such as stripe size) to show a progression of the effect. When running tests you've to take care the system is reset into the same initial state before each test, so you'll normally also try to include some baseline test between tests that should give the same results each time and also take the average of a number of runs (while also reporting some measure of the variation within each set to make sure that remains low, typically a low single digit percentage). Since we're mostly concerned about splitting, you'll want to monitor iostat to see if that gives you enough information to home in on suitable configurations for (1). Failing that, you might need to instrument the kernels to tell you the sizes of the bios being created and the amount of splitting actually happening. Striping was mentioned because it forces splitting. So show the progression from tiny stripes to huge stripes. (Ensure all the devices providing the stripes have identical characteristics, but you can test with slow and fast underlying devices.) You may also want to test systems with a restricted amount of available memory to show how the splitting via worker thread performs. (Again, instrument to prove the extent to which the new code is being exercised.) Alasdair -- dm-devel mailing list dm-devel@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/dm-devel
