This patch adds the missing options from the multipathd.8 man page. It also fixes a typo in a log message from the alua prioritizer. Signed-off-by: Benjamin Marzinski <bmarzins@xxxxxxxxxx> --- libmultipath/prioritizers/alua.c | 4 ++-- multipathd/multipathd.8 | 29 +++++++++++++++++++++++++++++ 2 files changed, 31 insertions(+), 2 deletions(-) diff --git a/libmultipath/prioritizers/alua.c b/libmultipath/prioritizers/alua.c index 4165ec6..b967ec7 100644 --- a/libmultipath/prioritizers/alua.c +++ b/libmultipath/prioritizers/alua.c @@ -119,10 +119,10 @@ int getprio (struct path * pp, char * args) condlog(0, "%s: couldn't get target port group", pp->dev); break; case ALUA_PRIO_GETAAS_FAILED: - condlog(0, "%s: couln't get asymmetric access state", pp->dev); + condlog(0, "%s: couldn't get asymmetric access state", pp->dev); break; case ALUA_PRIO_TPGS_FAILED: - condlog(3, "%s: couln't get supported alua states", pp->dev); + condlog(3, "%s: couldn't get supported alua states", pp->dev); break; } } diff --git a/multipathd/multipathd.8 b/multipathd/multipathd.8 index 6da9d2b..358141d 100644 --- a/multipathd/multipathd.8 +++ b/multipathd/multipathd.8 @@ -80,6 +80,9 @@ Show all available block devices by name including the information if they are b .B list|show status Show the number of path checkers in each possible state, the number of monitored paths, and whether multipathd is currently handling a uevent. .TP +.B list|show daemon +Show the current state of the multipathd daemon +.TP .B add path $path Add a path to the list of monitored paths. $path is as listed in /sys/block (e.g. sda). .TP @@ -107,6 +110,13 @@ Sets map $map into suspend state. .B resume map|multipath $map Resumes map $map from suspend state. .TP +.B reset map|multipath $map +Reassign existing device-mapper table(s) use use the multipath device, instead +of its path devices. +.TP +.B reload map|multipath $map +Reload a multipath device. +.TP .B fail path $path Sets path $path into failed state. .TP @@ -125,8 +135,27 @@ Disable queuing on multipathed map $map .B restorequeueing map|multipath $map Restore queuing on multipahted map $map .TP +.B forcequeueing daemon +Forces multipathd into queue_without_daemon mode, so that no_path_retry queueing +will not be disabled when the daemon stops +.TP +.B restorequeueing daemon +Restores configured queue_without_daemon mode +.TP +.B map|multipath $map setprstatus +Enable persistent reservation management on $map +.TP +.B map|multipath $map unsetprstatus +Disable persistent reservation management on $map +.TP +.B map|multipath $map getprstatus +Get the current persistent reservation management status of $map +.TP .B quit|exit End interactive session. +.TP +.B shutdown +Stop multipathd. .SH "SYSTEMD INTEGRATION" When compiled with systemd support two systemd service files are -- 1.8.3.1 -- dm-devel mailing list dm-devel@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/dm-devel
