On Mon, Jun 20, 2011 at 01:22:57PM +0100, Joe Thornber wrote: > I've just pushed an interface change for multisnap. Ignore the previous message, it turned out to be bogus. So now resizing is implemented as follows: - new-thin still takes a size arg new-thin <id> <size in sectors> - There is a resize message: resize <id> <size in sectors> - The target length doesn't have to correspond to the size of the thin device. Writes beyond the end will cause IO error. - Multiple targets may point to the same thin device. If you make more than one active then it is a user error. Much like using a linear target to map multiple devices to the same physical disk. - Joe -- dm-devel mailing list dm-devel@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/dm-devel