Thanks for the response Wayne, but this does me no good. You cannot use
the /dev/disk/by-id/* entries for device.map. You have to use the block
device and not a link or dm-* device name.
Essentially, I need to know which underlying paths can be written to
directly.
-David
berthiaume_wayne@xxxxxxx wrote:
Hi David.
For SLES you should be using
/dev/disk/by-id/36006016094511600449d92ae1937d611-part2 for a typical
root partition.
Regards,
Wayne.
-----Original Message-----
From: dm-devel-bounces@xxxxxxxxxx [mailto:dm-devel-bounces@xxxxxxxxxx]
On Behalf Of David Huffman
Sent: Thursday, February 18, 2010 8:15 PM
To: dm-devel@xxxxxxxxxx
Subject: multipath: Determine which device to use for
grubdevice.map file
I need to configure a dm-multipath device (mpatha) as a boot disk in a
script. For RHEL it appears I can put the mpath device in my device.map
file. However, for SLES 11 if I use the mpath device, grub fails with
"Floating point exception". For SLES I have to use the underlying path
device (sd[a-z]).
I know which devices make up my multipath disk. Here is an example that
shows my problem.
mpatha (36006016094511600449d92ae1937d611) dm-0 DGC,DISK
[size=50G][features=1 queue_if_no_path][hwhandler=1 emc][rw]
\_ round-robin 0 [prio=2][active]
\_ 2:0:1:0 sdd 8:48 [active][ready]
\_ 3:0:1:0 sdf 8:80 [active][ready]
\_ round-robin 0 [prio=0][enabled]
\_ 2:0:0:0 sdc 8:32 [active][ready]
\_ 3:0:0:0 sde 8:64 [active][ready]
Out of the 4 paths, only two (sdd and sdf) are active. This output is
not very good to parse through in a script to determine which disks I
can specify in my device.map file. Is there a command or better way to
determine which underlying paths I can use in my device.map file.
For clarification, here is a breakdown of my device.map entries and the
results:
(hd0) /dev/mapper/mpatha - FAIL with "Floating point exception"
(hd0) /dev/sdc - FAIL with "Error 21: Selected disk does not exist"
(hd0) /dev/sdd - Success!!!
I would rather put the mpath device in device.map, but that does not
appear to be an option for SLES. Is there a way to determine the
underlying path device that is "active" and not just enabled?
Right now I can run "dd if=/dev/sdc of=/dev/null bs=512 count=1
2>/dev/null; echo $?"
This will tell me in the device can be written to. Any suggestions would
be helpful.
- David
--
dm-devel mailing list
dm-devel@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/dm-devel
--
dm-devel mailing list
dm-devel@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/dm-devel
--
dm-devel mailing list
dm-devel@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/dm-devel
