Hi Vivek, Vivek Goyal <vgoyal@xxxxxxxxxx> wrote: > - Secondly, personally I think it more twisted also. Following is the > small code to setup two ioband devices ioband1 and ioband2 and two > additional groups on ioband1 device using cgroup interface. > The latest dm-ioband and blkio-cgroup, configurations can be done through the cgroup interface once a dm-device is created, blkio.setting file is appered under the cgroup directory. There is no need to run "dmsetup message" command and care the the blkio.id anymore. The following is an example script based on yours. *********************************************************************** echo "0 $(blockdev --getsize /dev/sdd1) ioband /dev/sdd1 1 0 0 cgroup" "weight 0 :100" | dmsetup create ioband1 mount -t cgroup -o blkio hier1 /cgroup/ioband mkdir /cgroup/ioband/test1 /cgroup/ioband/test2 echo ioband1 200 > /cgroup/ioband/test1/blkio.settings echo ioband1 100 > /cgroup/ioband/test2/blkio.settings mount /dev/mapper/ioband1 /mnt/sdd1 > For status of various settings one needs to use "dmsetup status" and > "dmsetup table" commands. Look at the output of these commands with just > two groups. Output for all the groups is on a single line. Think of the > situation when there are 7-8 groups and how bad it will look. > > #dmsetup status > ioband2: 0 40355280 ioband 1 -1 105 0 834 1 0 8 > ioband1: 0 37768752 ioband 1 -1 105 0 834 1 0 8 2 0 0 0 0 0 0 3 0 0 0 0 0 0 I'll provide blkio.stat file to get statistics per cgroup in the next release. > > Once we create a dm-ioband device, the device can be configured > > through the cgroup interface. I think it will not severly limit its > > usefulness. > > To create the device once you need dm-tools and libcgroup needs to learn > how to make various use of various dm commands. It also needs to learn how > to parse outputs of "dmsetup table" and "dmsetup status" commands and > consolidate that information. > > This is despite the fact that it is using cgroup interface finally to > group the task. But libcgroup still need to propagate cgroup id to > individual ioband devices. We still need to use dmsetup for the device creation, but It is not too much pain. I think it would be better If dm-ioband is intergrated into LVM, then we can handle dm-ioband devies in almost the same manner as other LV devices. Thanks, Ryo Tsuruta -- dm-devel mailing list dm-devel@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/dm-devel
