RHEL Steps worked perfectly for me but i have a question for SLES installation. Question. While installing SLES on multipath devices, the second step says: " 2. Complete the installation. Let the system boot up in multiuser mode. Make sure the root device, swap device are all referenced by their by-id device node entries instead of /dev/sd* type names. If they are not, fix them first." How do you check that root device and swap device are referenced by their by-id? And if it is not referenced by the by-id, how do I fix it? Re-install? Thanks and Regards, Pradipmaya. On Dec 19, 2007 1:18 PM, Chandra Seetharaman <sekharan@xxxxxxxxxx> wrote: > I am working on a multipath usage document. Attached is the installation > section of that document. > > Note that it is written for RHEL5 U1 and SLES10 SP1. > > Good Luck, > > chandra > > > On Wed, 2007-12-19 at 13:02 -0800, Pradipmaya Maharana wrote: > > Hi All, > > > > Is there a process/document that talks about how to configure > > root/boot device for multipath? > > > > Thanks and Regards, > > Pradipmaya. > > > > -- > > dm-devel mailing list > > dm-devel@xxxxxxxxxx > > https://www.redhat.com/mailman/listinfo/dm-devel > -- > > ---------------------------------------------------------------------- > Chandra Seetharaman | Be careful what you choose.... > - sekharan@xxxxxxxxxx | .......you may get it. > ---------------------------------------------------------------------- > > > -- > dm-devel mailing list > dm-devel@xxxxxxxxxx > https://www.redhat.com/mailman/listinfo/dm-devel > -- dm-devel mailing list dm-devel@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/dm-devel
