W dniu 20.10.2015 o 18:22, Andrzej Hajda pisze: > DECON-TV(Display and Enhancement Controller for TV) is a variation > of DECON IP. Its main purpose is to produce video stream for HDMI IP. > > Signed-off-by: Andrzej Hajda <a.hajda@xxxxxxxxxxx> > --- > .../devicetree/bindings/video/exynos5433-decon.txt | 21 ++++++++++++--------- > 1 file changed, 12 insertions(+), 9 deletions(-) > > diff --git a/Documentation/devicetree/bindings/video/exynos5433-decon.txt b/Documentation/devicetree/bindings/video/exynos5433-decon.txt > index 3dff78b..2a88c8d 100644 > --- a/Documentation/devicetree/bindings/video/exynos5433-decon.txt > +++ b/Documentation/devicetree/bindings/video/exynos5433-decon.txt > @@ -5,24 +5,27 @@ Exynos series of SoCs which transfers the image data from a video memory > buffer to an external LCD interface. > > Required properties: > -- compatible: value should be "samsung,exynos5433-decon"; > +- compatible: value should be one of: > + "samsung,exynos5433-decon", "samsung,exynos5433-decon-tv"; Until this point it looked good. > - reg: physical base address and length of the DECON registers set. > -- interrupts: should contain a list of all DECON IP block interrupts in the > - order: VSYNC, LCD_SYSTEM. The interrupt specifier format > - depends on the interrupt controller used. > -- interrupt-names: should contain the interrupt names: "vsync", "lcd_sys" > - in the same order as they were listed in the interrupts > - property. > +- interrupts: should contain interrupt specifier of VSYNC and optionally > + LCD_SYSTEM. The interrupt specifier format depends on > + the interrupt controller used. > +- interrupt-names: should contain the interrupt name "vsync" and optionally > + "lcd_sys" in the same order as they were listed in > + the interrupts property. The driver already did not require both interrupts, right? Only one of them? > - clocks: must include clock specifiers corresponding to entries in the > clock-names property. > - clock-names: list of clock names sorted in the same order as the clocks > property. Must contain "pclk", "aclk_decon", "aclk_smmu_decon0x", > "aclk_xiu_decon0x", "pclk_smmu_decon0x", clk_decon_vclk", > "sclk_decon_eclk" > + > +Optional properties: > - ports: contains a port which is connected to mic node. address-cells and > - size-cells must 1 and 0, respectively. > + size-cells must be 1 and 0, respectively. > - port: contains an endpoint node which is connected to the endpoint in the mic > - node. The reg value muset be 0. > + node. The reg value must be 0. > - i80-if-timings: specify whether the panel which is connected to decon uses > i80 lcd interface or mipi video interface. This node contains > no timing information as that of fimd does. Because there is > This is cleanup, please split it. Best regards, Krzysztof -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
