[PATCH 0/4]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




We need the OTP pin is gpio state before resetting the TSADC controller,
since the tshut polarity will generate a high signal.

Says:
The TSHUT temperature is setting more than 80 degree, the default
tshut polarity is HIGH.

If T > 80C, the OTP output the High Signal.
If T < 80C, the OTP output the Low Signal.

On the moment, the TSADC controller is reset, the tshut polarity will be
Low in a short period of time.

So:
If T < 80C, the OTP output the High Signal.
If T > 80C, the OTP output the Low Signal.

In some cases, the OTP pin is connected to the PMIC, maybe the PMIC can
accept the reset response time to avoid this issue.

In other words, the system will be always reboot if we make the OTP pin
is connected the others IC to control the power.

Tested on box board.



Caesar Wang (4):
  dt-bindings: Sync the dts to this document
  thermal: rockchip: ensure the otp state before resetting the
    controller
  thermal: rockchip: change the TSHUT default state
  ARM: dts: rockchip: Add the OTP gpio pinctrl

 .../bindings/thermal/rockchip-thermal.txt          |  5 ++--
 arch/arm/boot/dts/rk3288.dtsi                      |  9 ++++--
 drivers/thermal/rockchip_thermal.c                 | 34 +++++++++++++++++++++-
 3 files changed, 43 insertions(+), 5 deletions(-)

-- 
1.9.1

--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux