This patch adds IRQ support to STM32 gpios.
The EXTI controller has 16 lines dedicated to GPIOs.
EXTI line n can be connected to only line n of one of the GPIO ports, for
example EXTI0 can be connected to either PA0, or PB0, or PC0...
This port selection is done by specifying the port number into System
Config registers.
Signed-off-by: Maxime Coquelin <mcoquelin.stm32@xxxxxxxxx>
---
drivers/pinctrl/stm32/Kconfig | 1 +
drivers/pinctrl/stm32/pinctrl-stm32.c | 68 +++++++++++++++++++++++++++++++++++
2 files changed, 69 insertions(+)
diff --git a/drivers/pinctrl/stm32/Kconfig b/drivers/pinctrl/stm32/Kconfig
index 0f28841..b5cac5b 100644
--- a/drivers/pinctrl/stm32/Kconfig
+++ b/drivers/pinctrl/stm32/Kconfig
@@ -6,6 +6,7 @@ config PINCTRL_STM32
select PINMUX
select GENERIC_PINCONF
select GPIOLIB
+ select MFD_SYSCON
config PINCTRL_STM32F429
bool "STMicroelectronics STM32F429 pin control" if COMPILE_TEST && !MACH_STM32F429
diff --git a/drivers/pinctrl/stm32/pinctrl-stm32.c b/drivers/pinctrl/stm32/pinctrl-stm32.c
index 4ebceaa..954b596 100644
--- a/drivers/pinctrl/stm32/pinctrl-stm32.c
+++ b/drivers/pinctrl/stm32/pinctrl-stm32.c
@@ -8,6 +8,8 @@
#include <linux/clk.h>
#include <linux/gpio.h>
#include <linux/io.h>
+#include <linux/irq.h>
+#include <linux/mfd/syscon.h>
#include <linux/module.h>
#include <linux/of.h>
#include <linux/of_address.h>
@@ -20,6 +22,7 @@
#include <linux/pinctrl/pinctrl.h>
#include <linux/pinctrl/pinmux.h>
#include <linux/platform_device.h>
+#include <linux/regmap.h>
#include <linux/reset.h>
#include <linux/slab.h>
@@ -82,6 +85,9 @@ struct stm32_pinctrl {
struct stm32_gpio_bank *banks;
unsigned nbanks;
const struct stm32_pinctrl_match_data *match_data;
+ struct irq_domain *domain;
+ struct regmap *regmap;
+ struct regmap_field *irqmux[STM32_GPIO_PINS_PER_BANK];
};
static inline int stm32_gpio_pin(int gpio)
@@ -179,6 +185,22 @@ static int stm32_gpio_direction_output(struct gpio_chip *chip,
return 0;
}
+
+static int stm32_gpio_to_irq(struct gpio_chip *chip, unsigned offset)
+{
+ struct stm32_pinctrl *pctl = dev_get_drvdata(chip->dev);
+ struct stm32_gpio_bank *bank = gpio_chip_to_bank(chip);
+ unsigned int virq;
+
+ regmap_field_write(pctl->irqmux[offset], bank->range.id);
+
+ virq = irq_create_mapping(pctl->domain, offset);
+ if (!virq)
+ return -ENXIO;
+
+ return virq;
+}
+
static struct gpio_chip stm32_gpio_template = {
.request = stm32_gpio_request,
.free = stm32_gpio_free,
@@ -186,6 +208,7 @@ static struct gpio_chip stm32_gpio_template = {
.set = stm32_gpio_set,
.direction_input = stm32_gpio_direction_input,
.direction_output = stm32_gpio_direction_output,
+ .to_irq = stm32_gpio_to_irq,
};
/* Pinctrl functions */
@@ -731,6 +754,47 @@ static int stm32_gpiolib_register_bank(struct stm32_pinctrl *pctl,
return 0;
}
+static int stm32_pctrl_dt_setup_irq(struct platform_device *pdev,
+ struct stm32_pinctrl *pctl)
+{
+ struct device_node *np = pdev->dev.of_node, *parent;
+ struct device *dev = &pdev->dev;
+ struct regmap *rm;
+ int offset, ret, i;
+
+ parent = of_irq_find_parent(np);
+ if (!parent)
+ return -ENXIO;
+
+ pctl->domain = irq_find_host(parent);
+ if (!pctl->domain)
+ return -ENXIO;
+
+ pctl->regmap = syscon_regmap_lookup_by_phandle(np, "st,syscfg");
+ if (IS_ERR(pctl->regmap))
+ return PTR_ERR(pctl->regmap);
+
+ rm = pctl->regmap;
+
+ ret = of_property_read_u32_index(np, "st,syscfg", 1, &offset);
+ if (ret)
+ return ret;
+
+ for (i = 0; i < STM32_GPIO_PINS_PER_BANK; i++) {
+ struct reg_field mux;
+
+ mux.reg = offset + (i / 4) * 4;
+ mux.lsb = (i % 4) * 4;
+ mux.msb = mux.lsb + 3;
+
+ pctl->irqmux[i] = devm_regmap_field_alloc(dev, rm, mux);
+ if (IS_ERR(pctl->irqmux[i]))
+ return PTR_ERR(pctl->irqmux[i]);
+ }
+
+ return 0;
+}
+
static int stm32_pctrl_build_state(struct platform_device *pdev)
{
struct stm32_pinctrl *pctl = platform_get_drvdata(pdev);
@@ -823,6 +887,10 @@ int stm32_pctl_probe(struct platform_device *pdev)
}
}
+ ret = stm32_pctrl_dt_setup_irq(pdev, pctl);
+ if (ret)
+ return ret;
+
pins = devm_kcalloc(&pdev->dev, pctl->match_data->npins, sizeof(*pins),
GFP_KERNEL);
if (!pins)
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
