Hi Tony,
On 10/12/2015 04:43 PM, Tony Lindgren wrote:
> * Suman Anna <s-anna@xxxxxx> [151002 16:27]:
>> The DSP_SYSTEM sub-module is a dedicated system control logic
>> module present within a DRA7 DSP processor sub-system. This
>> module is responsible for power management, clock generation
>> and connection to the device PRCM module.
>>
>> Add a syscon node for this module for the DSP1 processor
>> sub-system. This is added as a syscon node as it is a common
>> configuration module that can be used by the different IOMMU
>> instances and the corresponding remoteproc device.
>>
>> The node is added to the common dra7.dtsi file, as the DSP1
>> processor sub-system is mostly common across all the variants
>> of the DRA7 SoC family.
>>
>> Signed-off-by: Suman Anna <s-anna@xxxxxx>
>> ---
>> arch/arm/boot/dts/dra7.dtsi | 5 +++++
>> 1 file changed, 5 insertions(+)
>>
>> diff --git a/arch/arm/boot/dts/dra7.dtsi b/arch/arm/boot/dts/dra7.dtsi
>> index e289c706d27d..62055094e8d5 100644
>> --- a/arch/arm/boot/dts/dra7.dtsi
>> +++ b/arch/arm/boot/dts/dra7.dtsi
>> @@ -292,6 +292,11 @@
>> #thermal-sensor-cells = <1>;
>> };
>>
>> + dsp1_system: dsp_system@40d00000 {
>> + compatible = "syscon";
>> + reg = <0x40d00000 0x100>;
>> + };
>> +
>> sdma: dma-controller@4a056000 {
>> compatible = "ti,omap4430-sdma";
>> reg = <0x4a056000 0x1000>;
>
> Hmm so why would you want to set up a complete device as a syscon
> mapping rather than just doing ioremap on it?
>
> What drivers will be sharing access to these registers?
Two different instances of the MMU for now, both get probed
independently. But there are other registers which a remoteproc driver
will mostly be interested in (like DSP_SYS_STAT for knowing the C66x
idle/active status).
regards
Suman
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
