> -----Original Message----- > From: Bastien Nocera [mailto:hadess@xxxxxxxxxx] > Sent: 25 September, 2015 17:41 > To: Tirdea, Irina; Dmitry Torokhov; Aleksei Mamlin; linux-input@xxxxxxxxxxxxxxx > Cc: Mark Rutland; Purdila, Octavian; linux-kernel@xxxxxxxxxxxxxxx; devicetree@xxxxxxxxxxxxxxx > Subject: Re: [PATCH v6 4/9] Input: goodix - write configuration data to device > > On Tue, 2015-09-15 at 17:31 +0300, Irina Tirdea wrote: > > Goodix devices can be configured by writing custom data to the device > > at > > init. The configuration data is read with request_firmware from > > "goodix_<id>_cfg.bin", where <id> is the product id read from the > > device > > (e.g.: goodix_911_cfg.bin for Goodix GT911, goodix_9271_cfg.bin for > > GT9271). > > > > The configuration information has a specific format described in the > > Goodix > > datasheet. It includes X/Y resolution, maximum supported touch > > points, > > interrupt flags, various sesitivity factors and settings for advanced > > sensitivity. Will fix this in next version of the patches. I will wait for you reply on the gpio issue before sending a new version. Thanks, Irina ��.n��������+%������w��{.n����z�{��ܨ}���Ơz�j:+v�����w����ޙ��&�)ߡ�a����z�ޗ���ݢj��w�f
