Enable the otg/drc usb controller on the Marsboard A10. Similar to Cubieboard, the 5V of the otg is directly connected to the general 5V, so we only use the id pin. Signed-off-by: Aleksei Mamlin <mamlinav@xxxxxxxxx> --- arch/arm/boot/dts/sun4i-a10-marsboard.dts | 19 +++++++++++++++++++ 1 file changed, 19 insertions(+) diff --git a/arch/arm/boot/dts/sun4i-a10-marsboard.dts b/arch/arm/boot/dts/sun4i-a10-marsboard.dts index 02158bc..9a012db 100644 --- a/arch/arm/boot/dts/sun4i-a10-marsboard.dts +++ b/arch/arm/boot/dts/sun4i-a10-marsboard.dts @@ -154,6 +154,10 @@ status = "okay"; }; +&otg_sram { + status = "okay"; +}; + &pio { led_pins_marsboard: led_pins@0 { allwinner,pins = "PB5", "PB6", "PB7", "PB8"; @@ -161,6 +165,13 @@ allwinner,drive = <SUN4I_PINCTRL_10_MA>; allwinner,pull = <SUN4I_PINCTRL_NO_PULL>; }; + + usb0_id_detect_pin: usb0_id_detect_pin@0 { + allwinner,pins = "PH4"; + allwinner,function = "gpio_in"; + allwinner,drive = <SUN4I_PINCTRL_10_MA>; + allwinner,pull = <SUN4I_PINCTRL_PULL_UP>; + }; }; ®_usb1_vbus { @@ -184,7 +195,15 @@ status = "okay"; }; +&usb_otg { + dr_mode = "otg"; + status = "okay"; +}; + &usbphy { + pinctrl-names = "default"; + pinctrl-0 = <&usb0_id_detect_pin>; + usb0_id_det-gpio = <&pio 7 4 GPIO_ACTIVE_HIGH>; /* PH4 */ usb1_vbus-supply = <®_usb1_vbus>; usb2_vbus-supply = <®_usb2_vbus>; status = "okay"; -- 2.4.9 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html