Hi Sascha,
On 23.09.2015 16:37, Sascha Hauer wrote:
> This adds support for the Mediatek thermal controller found on MT8173
> and likely other SoCs.
> The controller is a bit special. It does not have its own ADC, instead
> it controls the on-SoC AUXADC via AHB bus accesses. For this reason
> we need the physical address of the AUXADC. Also it controls a mux
> using AHB bus accesses, so we need the APMIXEDSYS physical address aswell.
>
> Signed-off-by: Sascha Hauer <s.hauer@xxxxxxxxxxxxxx>
> Reviewed-by: Daniel Kurtz <djkurtz@xxxxxxxxxxxx>
> ---
> drivers/thermal/Kconfig | 8 +
> drivers/thermal/Makefile | 1 +
> drivers/thermal/mtk_thermal.c | 537 ++++++++++++++++++++++++++++++++++++++++++
> 3 files changed, 546 insertions(+)
> create mode 100644 drivers/thermal/mtk_thermal.c
>
[snip]
> +
> + auxadc = of_parse_phandle(np, "mediatek,auxadc", 0);
> + if (!auxadc) {
> + dev_err(&pdev->dev, "missing auxadc node\n");
> + return -ENODEV;
> + }
> +
> + auxadc_phys_base = of_get_phys_base(auxadc);
in case of OF_DYNAMIC enabled of_parse_phandle() requires of_node_put(),
which is fine to place right here.
> + if (auxadc_phys_base == OF_BAD_ADDR) {
> + dev_err(&pdev->dev, "Can't get auxadc phys address\n");
> + return -EINVAL;
> + }
> +
[snip]
> +
> + /*
> + * These calibration values should finally be provided by the
> + * firmware or fuses. For now use default values.
> + */
> + mt->calib_slope = -123;
> + mt->calib_offset = 465124;
> +
> + for (i = 0; i < MT8173_NUM_ZONES; i++)
> + mtk_thermal_init_bank(mt, i, apmixed_phys_base, auxadc_phys_base);
> +
> + platform_set_drvdata(pdev, mt);
> +
> + for (i = 0; i < MT8173_NUM_ZONES; i++) {
> + struct mtk_thermal_bank *bank = &mt->banks[i];
> +
> + bank->tzd = thermal_zone_of_sensor_register(&pdev->dev, i, bank,
> + &mtk_thermal_ops);
I would propose to add return value checks here, otherwise there might
be an oops in mtk_thermal_remove(), if something goes wrong.
--
With best wishes,
Vladimir
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
