The updated binding provides a way to set clock-ID and direction parameters for DAI drivers set_sysclk() call back. Signed-off-by: Jyri Sarha <jsarha@xxxxxx> --- I proposed something similar about a year ago, but Mark rejected that at the time. This RFC is to start that discussion again. This time before I do any code changes. Best regards, Jyri Documentation/devicetree/bindings/sound/simple-card.txt | 17 ++++++++++++++++- 1 file changed, 16 insertions(+), 1 deletion(-) diff --git a/Documentation/devicetree/bindings/sound/simple-card.txt b/Documentation/devicetree/bindings/sound/simple-card.txt index cf3979e..d10bf2d 100644 --- a/Documentation/devicetree/bindings/sound/simple-card.txt +++ b/Documentation/devicetree/bindings/sound/simple-card.txt @@ -76,6 +76,7 @@ Optional CPU/CODEC subnodes properties: - dai-tdm-slot-num : Please refer to tdm-slot.txt. - dai-tdm-slot-width : Please refer to tdm-slot.txt. - clocks / system-clock-frequency : specify subnode's clock if needed. + it can be specified via "clocks" if system has clock node (= common clock), or "system-clock-frequency" (if system doens't support common clock) @@ -83,7 +84,21 @@ Optional CPU/CODEC subnodes properties: enabled with clk_prepare_enable() in dai startup() and disabled with clk_disable_unprepare() in dai - shutdown(). + shutdown(). "system-clock-frequency" + can also be an array if more than one + clock is described. +- clock-ids : An array of clock ID integers, + preferrably defined in DT header. + Each entry corresponds to the same + index postion first in "clocks" and + after the end of clocks array to + "system-clock-frequency" array. +- clock-dirs : An array of integers describing + clock directions: CLK_IN (= 0) or + OUT (= 1). Entries in the array + refer to clocks in the same way as + in clock-ids property. + Example 1 - single DAI link: -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html