On 8/12/2015 2:49 AM, Leo Yan wrote: > Hi Stephen, > > On Tue, Aug 11, 2015 at 05:38:17PM -0700, Stephen Boyd wrote: >> On 08/04, Leo Yan wrote: >>> This series adds support for hisilicon stub clock driver. On hi6220, >>> the bootloader needs load the firmware image and set info for OPPs; >>> after run into kernel, the stub clock driver is used to communicate >>> w/t firmware for cpu dynamic frequency scaling. >>> >>> In patch series v1/v2, the stub clock driver simply writes request in >>> sram and send ipc to firmware; For patch series v3, the firmware has >>> been upgraded to use mailbox, so stub clock driver will call standard >>> mailbox APIs to request mailbox channel and send message to firmware. >>> >>> Patch 4 adds stub clock node into dts and it references mailbox with >>> phandle, so patch 4 will depend on mailbox driver's patch series [1]. >>> These patches have been tested on 96board hikey and is used by cpufreq >>> driver. >> >> The To: list is everyone, so I'm not sure who is supposed to >> apply these patches. I'd like to take patches 1, 2, and 3 through >> the clk tree though. > > Thanks, you could take first three patches. For patch 4, i will > re-send it after mailbox driver's patches have been merged. Hi Leo, > Wei Xu, is this okay for you? OK :) Best Regards, Wei > > Thanks, > Leo Yan > > . > -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html