It is used to override the default setting for burst size, changing burst size takes effect only when the SBUSCFG.AHBBRST = 0. Signed-off-by: Peter Chen <peter.chen@xxxxxxxxxxxxx> --- Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt | 10 ++++++++++ 1 file changed, 10 insertions(+) diff --git a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt index d52a747..d71ef07 100644 --- a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt +++ b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt @@ -37,6 +37,14 @@ Optional properties: property is used to change AHB burst configuration, check the chipidea spec for meaning of each value. If this property is not existed, it will use the reset value. +- tx-burst-size-dword: it is vendor dependent, the tx burst size in dword + (4 bytes), This register represents the maximum length of a the burst + in 32-bit words while moving data from system memory to the USB + bus, changing this value takes effect only the SBUSCFG.AHBBRST is 0. +- rx-burst-size-dword: it is vendor dependent, the rx burst size in dword + (4 bytes), This register represents the maximum length of a the burst + in 32-bit words while moving data from the USB bus to system memory, + changing this value takes effect only the SBUSCFG.AHBBRST is 0. Example: @@ -51,4 +59,6 @@ Example: gadget-itc-setting = <0x4>; /* 4 micro-frames */ /* Incremental burst of unspecified length */ ahb-burst-config = <0x0>; + tx-burst-size-dword = <0x10>; /* 64 bytes */ + rx-burst-size-dword = <0x10>; }; -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
