hi, On Fri, 2015-07-31 at 14:37 +0100, Mark Rutland wrote: > Hi, > > > > > + - mediatek,usb-wakeup: to access usb wakeup control register > > > > > > What exactly does this property imply? > > > > > There are some control registers for usb wakeup which are put in another > > module, here to get the node of that module, and then use regmap and > > syscon to operate it. > > Ok. You need to specify the type of this property (i.e. that it is a > phandle to a syscon node). The description makes it sound like a boolean. > Is it ok to add a prefix of syscon, and name it syscon-usb-wakeup? > > > > > > + - mediatek,wakeup-src: 1: ip sleep wakeup mode; 2: line state wakeup > > > > + mode; others means don't enable wakeup source of usb > > > > > > This sounds like configuration rather than a hardware property. Why do > > > you think this needs to be in the DT? > > > > > Yes, it's better to put it in the DT. > > That doesn't answer my question. > > _why_ do you think this needs to be in the DT? What do you think is > better for it being there? > It is unthoughtful to put it here; There is different configuration on platforms, such as on tablet which only needs line-state wakeup (because system can't enter suspend when plug in usb cable, so don't need ip-sleep-wakeup to remote wakeup system), and on box just needs ip-sleep wakeup mode. so it is better to put in each board's dts. > > > > > > + - mediatek,u2port-num: the number should not greater than the number > > > > + of phys > > > > > > What exactly does this property imply? > > > > > On some platform, it only makes use of partial usb ports, so disable > > others to save power. > > What exactly do you mean by "partial USB ports"? > > If a phy isn't wired up, it won't be listed in the phys property, if it > is then disabling it sounds like a run-time decision. > Yes, you are right. This confuse me a little before. It was a property of old phy driver at first, and then ported it here, so did not remove it temp. After I re-write the phy driver, I will remove it. Thanks a lot. > Thanks, > Mark. -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html