Re: [linux-sunxi] [RFC] ARM: dts: sunxi: Add regulators and board-specific operating points for LeMaker BananaPi

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




Hi,

On 07/28/2015 05:09 PM, Timo Sigurdsson wrote:
Hi,

Hans de Goede schrieb am 28.07.2015 16:24:
I've no problem with Timo submitting a cleaned up version of his
patch and you taking that instead. I just wanted to point out that
I do have a similar patch pending.

Ok, I will do that. It might take a couple of days, though, as I will be moving
moving in the next few days as well.

However, another question first then: What maximum voltage for the dcdc2
regulator should we use then? You used 1.5V, I used 1.45V so far, which is what
Cubieboard 2 and Cubietruck use.

But after the discussion about overvoltaged settings, I'm wondering whether we
should limit the regulartor (and not only the opp) to 1.40V as well? Or is
1.45V ok for everybody here?

The datasheets lists a max cpu-voltage of 1.40V, so lets stick with that.

Regards,

Hans
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux