Hi Andrey,
On Mon, Jul 20, 2015 at 11:35:43PM +0300, Andrey Danin wrote:
> Initialization code is based on NVEC driver.
>
> There is a HW bug in AP20 that was also mentioned in kernel sources
> for Toshiba AC100.
>
> Signed-off-by: Andrey Danin <danindrey@xxxxxxx>
Still doesn't work for me and I think I understand why. Do you run your
I2C controller in slave mode only? That might work, but using it in
master/slave mode simultanously won't work yet as I see it:
* After every transfer (as master), clocks get disabled. I assume the IP
core won't be able to detect its own address then.
* There is this code in tegra_i2c_init():
if (!i2c_dev->is_dvc) {
u32 sl_cfg = i2c_readl(i2c_dev, I2C_SL_CNFG);
sl_cfg |= I2C_SL_CNFG_NACK | I2C_SL_CNFG_NEWSL;
i2c_writel(i2c_dev, sl_cfg, I2C_SL_CNFG);
i2c_writel(i2c_dev, 0xfc, I2C_SL_ADDR1);
i2c_writel(i2c_dev, 0x00, I2C_SL_ADDR2);
}
It probably messes up the slave initialization in tegra_reg_slave().
At least I see that the slave address gets overwritten when I peek
the register after boot.
Does that make sense to you?
Thanks,
Wolfram
Attachment:
signature.asc
Description: Digital signature
