Hello Lee, Thanks for your feedback. On 07/23/2015 05:16 PM, Lee Jones wrote: > On Fri, 17 Jul 2015, Javier Martinez Canillas wrote: > >> The MAX77802 is a chip that contains regulators, 2 32kHz clocks, >> a RTC and an I2C interface to program the individual components. >> >> The are already DT bindings for the regulators and clocks and >> these reference to a bindings/mfd/max77802.txt file, that didn't >> exist, for the details about the PMIC. >> >> Signed-off-by: Javier Martinez Canillas <javier@xxxxxxxxxxxxxxx> >> >> --- >> >> Changes in v2: >> - Use the correct "maxim,max77802" compatible string. >> Suggested by Krzysztof Kozlowski >> - Use a pmic generic node name for the max77802 node example. >> Suggested by Sergei Shtylyov. >> >> Documentation/devicetree/bindings/mfd/max77802.txt | 26 ++++++++++++++++++++++ >> 1 file changed, 26 insertions(+) >> create mode 100644 Documentation/devicetree/bindings/mfd/max77802.txt >> >> diff --git a/Documentation/devicetree/bindings/mfd/max77802.txt b/Documentation/devicetree/bindings/mfd/max77802.txt >> new file mode 100644 >> index 000000000000..c60cdec50d36 >> --- /dev/null >> +++ b/Documentation/devicetree/bindings/mfd/max77802.txt >> @@ -0,0 +1,26 @@ >> +Maxim MAX77802 multi-function device >> + >> +The Maxim MAX77802 is a power management chip (PMIC) that contains 10 high >> +efficiency Buck regulators, 32 Low-dropout (LDO) regulators used to power > > Would be good to capitalise the works in the acronyms, so > "Low-DropOut" and "Power Management IC". > Ok. >> +up application processors and peripherals, a 2-channel 32kHz clock outputs, >> +a Real-Time-Clock (RTC) and a I2C interface to program the individual >> +regulators, clocks outputs and the RTC. >> + >> +Binding for the built-in 32k clock generator block is defined separately >> +in the bindings/clk/maxim,max77802.txt file and binding for the regulators > > s/bindings/../ > Ok. >> +is defined in the bindings/regulator/max77802.txt file. >> + >> +Required properties: >> +- compatible : Must be "maxim,max77802"; >> +- reg : Specifies the i2c slave address of PMIC block. > > s/i2c/I2C/ > >> +- interrupts : This i2c device has an IRQ line connected to the main SoC. > > As above. > Ok. I'll change it. >> +- interrupt-parent : The parent interrupt controller. >> + >> +Example: >> + >> + max77802: pmic@09 { >> + compatible = "maxim,max77802"; >> + interrupt-parent = <&intc>; >> + interrupts = <26 0>; > > Is there a define in include/dt-bindings/interrupt-controller to > replace 0? IRQ_TYPE_NONE perhaps. > Yes, I'll change that as well. >> + reg = <0x09>; >> + }; > Best regards, -- Javier Martinez Canillas Open Source Group Samsung Research America -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html