On 4 June 2015 at 19:15, Richard Cochran <richardcochran@xxxxxxxxx> wrote: > On Thu, Jun 04, 2015 at 10:31:45AM +0200, Michal Suchanek wrote: >> You might want to try to run the bus at 60MHz or 80MHz and then the >> values would probably again be different. >> >> The first two values are set in DT so the logical place for setting >> the third is also in DT. >> >> Otherwise you would need some in-kernel table of these settings. > > Or a formula. > This formula probably needs to take into account - the unknown reason for the pl330 to fail transfer - the device transfer speed and transfer phase as set in DT - possibly device-specific latency and board-specific trace design and assembly tolerances Seriously, until I have at least a vague idea why the transfer fails I am not comfortable pulling some formula out of thin air and pretending I have a working patch. On the other hand, a parameter you can set in the DT and which comes with a suggested value which can be tuned depending on the system seems more viable. Thanks Michal -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
