[PATCH v4] ARM: shmobile: koelsch: make USB0 perform Host/Function switching

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




Both USB Host (pci0) and Function (USBHS) drivers are enabled.
The USB PHY driver determines which IP block should be connected
based on vbus and id signals read via gpios.

Note that switch SW5 and SW6 on Koelsch board needs to be set to
position 3 for this to work.

Signed-off-by: Phil Edworthy <phil.edworthy@xxxxxxxxxxx>

---
Not for upstream until the following patches have been accepted:
"usb: renesas_usbhs: Allow an OTG PHY driver to provide VBUS"
"phy: rcar-gen2 usb: Add Host/Function switching for USB0"
Hence, not signed off.

v4:
  - Changed prefix in title.

v3:
  - Remove "pinctrl-names" as well as "pinctrl-0" props.

v2:
  - Added -gpio to dts prop names of GPIO pins.
---
 arch/arm/boot/dts/r8a7791-koelsch.dts | 9 ++++-----
 1 file changed, 4 insertions(+), 5 deletions(-)

diff --git a/arch/arm/boot/dts/r8a7791-koelsch.dts b/arch/arm/boot/dts/r8a7791-koelsch.dts
index cffe33f..21c2fdc 100644
--- a/arch/arm/boot/dts/r8a7791-koelsch.dts
+++ b/arch/arm/boot/dts/r8a7791-koelsch.dts
@@ -615,8 +615,6 @@
 
 &pci0 {
 	status = "okay";
-	pinctrl-0 = <&usb0_pins>;
-	pinctrl-names = "default";
 };
 
 &pci1 {
@@ -627,13 +625,14 @@
 
 &hsusb {
 	status = "okay";
-	pinctrl-0 = <&usb0_pins>;
-	pinctrl-names = "default";
-	renesas,enable-gpio = <&gpio5 31 GPIO_ACTIVE_HIGH>;
 };
 
 &usbphy {
 	status = "okay";
+	renesas,pwr-gpio = <&gpio2 4 GPIO_ACTIVE_HIGH>;
+	renesas,id-gpio = <&gpio5 31 GPIO_ACTIVE_HIGH>;
+	renesas,vbus-gpio = <&gpio7 24 GPIO_ACTIVE_HIGH>;
+	renesas,vbus-pwr-gpio = <&gpio7 23 GPIO_ACTIVE_HIGH>;
 };
 
 &pcie_bus_clk {
-- 
1.9.1

--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux