On 09/06/15 18:07, Mark Brown wrote:
On Tue, Jun 09, 2015 at 01:59:36PM +0100, Srinivas Kandagatla wrote:
+ if (cpu_dai->id == MI2S_QUATERNARY) {
+ /* Configure the Quat MI2S to TLMM */
+ writel(readl(pdata->mic_iomux) |
+ MIC_CTRL_QUA_WS_SLAVE_SEL_10 |
+ MIC_CTRL_TLMM_SCLK_EN,
+ pdata->mic_iomux);
+
+ return 0;
+ } else if (cpu_dai->id == MI2S_PRIMARY) {
+ writel(readl(pdata->spkr_iomux) |
+ SPKR_CTL_PRI_WS_SLAVE_SEL_11,
+ pdata->spkr_iomux);
+
+ return 0;
+ }
Why not just do these one time at probe, we don't undo them when we shut
the DAI down?
If I do that Am afraid that the driver would loose the flexibility of
selecting different MI2S from DT level. Hardcoding which MI2S can got to
external or internal codec is something that I wanted to avoid from the
start.
I will add the shutdown code to reset the configuration.
+
+ dev_err(card->dev, "unsupported cpu dai configuration\n");
+
+ return -EINVAL;
It'd be clearer if this were part of the above code (which should still
be written as a switch statement) - I was just asking myself what
happens if we fall off the end of the if/else chain.
I will change this to switch case.
+ /**
+ * External codec is ADV7533
+ * and internal codec digital part is inside apq8016
+ * and analog part is in PMIC PM8916
+ **/
+ if (of_property_read_bool(np, "external"))
+ name = "ADV7533";
+ else
+ name = "WCD";
If this is all the property is doing why not just put a link name
property in the DT rather than this? That makes the driver a bit more
general and is more idiomatic.
Yes, it makes it more clear with link-name property. I will fix this in
next version.
+ dai_link->name = dai_link->stream_name = name;
Write two assignment statements, it's clearer and more idiomatic.
I will fix this too.
--srini
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
