On Mon, Jun 8, 2015 at 12:42 AM, Sanchayan Maity
<maitysanchayan@xxxxxxxxx> wrote:
> The driver currently does not take into account the minimum sample time
> as per the Figure 6-8 Chapter 9.1.1 12-bit ADC electrical characteristics.
> We set a static amount of cycles instead of considering the sample time as
> a given value, which depends on hardware characteristics.
>
> Determine sampling frequencies by first reading the device tree property
> node and then calculating the required Long Sample Time Adder (LSTAdder)
> value based on the ADC clock frequency and sample time value obtained
> from the device tree, this LSTAdder value is then used for calculating
> the sampling frequencies possible.
>
> Signed-off-by: Sanchayan Maity <maitysanchayan@xxxxxxxxx>
> ---
> .../devicetree/bindings/iio/adc/vf610-adc.txt | 6 ++
> drivers/iio/adc/vf610_adc.c | 74 ++++++++++++++++++++--
> 2 files changed, 76 insertions(+), 4 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/iio/adc/vf610-adc.txt b/Documentation/devicetree/bindings/iio/adc/vf610-adc.txt
> index 3eb40e2..4419126 100644
> --- a/Documentation/devicetree/bindings/iio/adc/vf610-adc.txt
> +++ b/Documentation/devicetree/bindings/iio/adc/vf610-adc.txt
> @@ -17,6 +17,11 @@ Recommended properties:
> - Frequency in normal mode (ADLPC=0, ADHSC=0)
> - Frequency in high-speed mode (ADLPC=0, ADHSC=1)
> - Frequency in low-power mode (ADLPC=1, ADHSC=0)
> + - fsl,min-sample-time: Minimum sampling time in nanoseconds. This value has
Add a "-ns' suffix.
Seems like this could be a common ADC property.
> + to be chosen according to the conversion mode and the connected analog
> + source resistance (R_as) and capacitance (C_as). Refer the datasheet's
> + operating requirements. A safe default across a wide range of R_as and
> + C_as as well as conversion modes is 1000ns.
>
> Example:
> adc0: adc@4003b000 {
> @@ -27,5 +32,6 @@ adc0: adc@4003b000 {
> clock-names = "adc";
> fsl,adck-max-frequency = <30000000>, <40000000>,
> <20000000>;
> + fsl,min-sample-time = <1000>;
> vref-supply = <®_vcc_3v3_mcu>;
> };
> diff --git a/drivers/iio/adc/vf610_adc.c b/drivers/iio/adc/vf610_adc.c
> index 480f335..bcae8fd 100644
> --- a/drivers/iio/adc/vf610_adc.c
> +++ b/drivers/iio/adc/vf610_adc.c
> @@ -68,6 +68,9 @@
> #define VF610_ADC_CLK_DIV8 0x60
> #define VF610_ADC_CLK_MASK 0x60
> #define VF610_ADC_ADLSMP_LONG 0x10
> +#define VF610_ADC_ADSTS_SHORT 0x100
> +#define VF610_ADC_ADSTS_NORMAL 0x200
> +#define VF610_ADC_ADSTS_LONG 0x300
> #define VF610_ADC_ADSTS_MASK 0x300
> #define VF610_ADC_ADLPC_EN 0x80
> #define VF610_ADC_ADHSC_EN 0x400
> @@ -124,6 +127,17 @@ enum conversion_mode_sel {
> VF610_ADC_CONV_LOW_POWER,
> };
>
> +enum lst_adder_sel {
> + VF610_ADCK_CYCLES_3,
> + VF610_ADCK_CYCLES_5,
> + VF610_ADCK_CYCLES_7,
> + VF610_ADCK_CYCLES_9,
> + VF610_ADCK_CYCLES_13,
> + VF610_ADCK_CYCLES_17,
> + VF610_ADCK_CYCLES_21,
> + VF610_ADCK_CYCLES_25,
> +};
> +
> struct vf610_adc_feature {
> enum clk_sel clk_sel;
> enum vol_ref vol_ref;
> @@ -132,6 +146,8 @@ struct vf610_adc_feature {
> int clk_div;
> int sample_rate;
> int res_mode;
> + u32 lst_adder_index;
> + u32 default_sample_time;
>
> bool calibration;
> bool ovwren;
> @@ -155,11 +171,13 @@ struct vf610_adc {
> };
>
> static const u32 vf610_hw_avgs[] = { 1, 4, 8, 16, 32 };
> +static const u32 vf610_lst_adder[] = { 3, 5, 7, 9, 13, 17, 21, 25 };
>
> static inline void vf610_adc_calculate_rates(struct vf610_adc *info)
> {
> struct vf610_adc_feature *adc_feature = &info->adc_feature;
> unsigned long adck_rate, ipg_rate = clk_get_rate(info->clk);
> + u32 adck_period, lst_addr_min;
> int divisor, i;
>
> adck_rate = info->max_adck_rate[adc_feature->conv_mode];
> @@ -174,6 +192,19 @@ static inline void vf610_adc_calculate_rates(struct vf610_adc *info)
> }
>
> /*
> + * Determine the long sample time adder value to be used based
> + * on the default minimum sample time provided.
> + */
> + adck_period = NSEC_PER_SEC / adck_rate;
> + lst_addr_min = adc_feature->default_sample_time / adck_period;
> + for (i = 0; i < ARRAY_SIZE(vf610_lst_adder); i++) {
> + if (vf610_lst_adder[i] > lst_addr_min) {
> + adc_feature->lst_adder_index = i;
> + break;
> + }
> + }
> +
> + /*
> * Calculate ADC sample frequencies
> * Sample time unit is ADCK cycles. ADCK clk source is ipg clock,
> * which is the same as bus clock.
> @@ -182,12 +213,13 @@ static inline void vf610_adc_calculate_rates(struct vf610_adc *info)
> * SFCAdder: fixed to 6 ADCK cycles
> * AverageNum: 1, 4, 8, 16, 32 samples for hardware average.
> * BCT (Base Conversion Time): fixed to 25 ADCK cycles for 12 bit mode
> - * LSTAdder(Long Sample Time): fixed to 3 ADCK cycles
> + * LSTAdder(Long Sample Time): 3, 5, 7, 9, 13, 17, 21, 25 ADCK cycles
> */
> adck_rate = ipg_rate / info->adc_feature.clk_div;
> for (i = 0; i < ARRAY_SIZE(vf610_hw_avgs); i++)
> info->sample_freq_avail[i] =
> - adck_rate / (6 + vf610_hw_avgs[i] * (25 + 3));
> + adck_rate / (6 + vf610_hw_avgs[i] *
> + (25 + vf610_lst_adder[adc_feature->lst_adder_index]));
> }
>
> static inline void vf610_adc_cfg_init(struct vf610_adc *info)
> @@ -347,8 +379,40 @@ static void vf610_adc_sample_set(struct vf610_adc *info)
> break;
> }
>
> - /* Use the short sample mode */
> - cfg_data &= ~(VF610_ADC_ADLSMP_LONG | VF610_ADC_ADSTS_MASK);
> + /*
> + * Set ADLSMP and ADSTS based on the Long Sample Time Adder value
> + * determined.
> + */
> + switch (adc_feature->lst_adder_index) {
> + case VF610_ADCK_CYCLES_3:
> + break;
> + case VF610_ADCK_CYCLES_5:
> + cfg_data |= VF610_ADC_ADSTS_SHORT;
> + break;
> + case VF610_ADCK_CYCLES_7:
> + cfg_data |= VF610_ADC_ADSTS_NORMAL;
> + break;
> + case VF610_ADCK_CYCLES_9:
> + cfg_data |= VF610_ADC_ADSTS_LONG;
> + break;
> + case VF610_ADCK_CYCLES_13:
> + cfg_data |= VF610_ADC_ADLSMP_LONG;
> + break;
> + case VF610_ADCK_CYCLES_17:
> + cfg_data |= VF610_ADC_ADLSMP_LONG;
> + cfg_data |= VF610_ADC_ADSTS_SHORT;
> + break;
> + case VF610_ADCK_CYCLES_21:
> + cfg_data |= VF610_ADC_ADLSMP_LONG;
> + cfg_data |= VF610_ADC_ADSTS_NORMAL;
> + break;
> + case VF610_ADCK_CYCLES_25:
> + cfg_data |= VF610_ADC_ADLSMP_LONG;
> + cfg_data |= VF610_ADC_ADSTS_NORMAL;
> + break;
> + default:
> + dev_err(info->dev, "error in sample time select\n");
> + }
>
> /* update hardware average selection */
> cfg_data &= ~VF610_ADC_AVGS_MASK;
> @@ -712,6 +776,8 @@ static int vf610_adc_probe(struct platform_device *pdev)
>
> of_property_read_u32_array(pdev->dev.of_node, "fsl,adck-max-frequency",
> info->max_adck_rate, 3);
> + of_property_read_u32(pdev->dev.of_node, "fsl,min-sample-time",
> + &info->adc_feature.default_sample_time);
>
> platform_set_drvdata(pdev, indio_dev);
>
> --
> 2.4.2
>
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
