Thanks to those who replied.
On 06/05/2015 07:30 PM, Guenter Roeck wrote:
> Hi Chris,
>
> On 06/04/2015 11:03 PM, Chris Packham wrote:
>> Hi,
>>
>> I'm working on a new board and one feature it as is a plug-in module
>> with an ADS7830 voltage monitor on it. This will be used during
>> manufacturing to sanity check that various voltage rails are within
>> expected ranges.
>>
>> I have a dts entry for the device as below (with some omissions for the
>> sake of clarity)
>>
>> soc {
>> internal-regs {
>> i2c@11000 {
>> ads7830@48 {
>> compatible = "ads7830";
>> reg = <0x48>;
>> };
>> };
>> };
>> };
>>
>> The problem is that when the manufacturing card is not installed the
>> device still shows up in /sys/class/hwmon/hwmon0/ and
>> /sys/bus/i2c/devices/0-0048/ despite it not actually being present. If I
>> was using an old style initialization I could use
>> i2c_new_probed_device() which I think would stop the drivers probe()
>> function from being called
>>
>> Looking at the ads7828_probe() function it doesn't actually do anything
>> with the i2c device before calling hwmon_device_register(). Some hwmon
>> drivers like lm73_probe() do attempt to read from the device and bail if
>> the read fails. I can probably fix my problem by doing something similar
>> in the ads7828_probe(), but there are other drivers that have a similar
>> probe function.
>>
> But that would be artificial in this case, and it could not be used to
> really
> detect the chip but would only prove that there is a chip at the
> selected i2c
> address. This is not really useful.
>
>> Is there a better way of getting the devicetree machinery to avoid the
>> call to the driver probe function in the first place?
>>
>
> The easiest solution would probably be to drop the entry from the
> devicetree file and instantiate the driver manually via sysfs when
> needed. Another option would be to load a different devicetree file
> if the chip is plugged in.
>
> You might also be able to use a devicetree overlay, but that would
> probably add too much complexity if the chip is only used in
> manufacturing.
Sounds like my best bet is to mark the nodes as disabled in the dts and
have my bootloader update them on the way through.��.n��������+%������w��{.n����z�{��ܨ}���Ơz�j:+v�����w����ޙ��&�)ߡ�a����z�ޗ���ݢj��w�f
