Hi Imre,
On 20/05/2015 23:14, Imre Kaloz wrote:
> This patch adds support for the Linksys WRT1200AC (Caiman) and
> the Linksys WRT1900AC v2 (Cobra).
>
> Both boards have:
>
> - 2 Marvell 88W8864 radios
> - 1 USB 3.0 port
> - 1 USB 2.0/eSATAp port
> - 2 Ethernet interfaces connected to a 88E6176 switch (1x WAN + 4x LAN)
> - 128MB NAND flash
> - 512MB RAM
>
> Signed-off-by: Imre Kaloz <kaloz@xxxxxxxxxxx>
>
> ---
> Changes since v1: added DSA support
> ---
> The only difference between the two boards is the radio configuration
> (2x2 vs 3x3), so everything except the leds (to be named properly)
> is in the dtsi file. When the wireless driver will be submitted
> upstream, the powertables (calibration data) will end up in the board
> specific files, tho.
it seems that you missed my comment about removing bootargs and just using
stdout-path = "serial0:115200n8";
If you agree and if there is no remark about the DSA part from Andrew, I can
take car of it while applying your patch on mvebu/dt.
Thanks,
Gregory
[...]
> --- /dev/null
> +++ b/arch/arm/boot/dts/armada-385-linksys.dtsi
[...]
> + chosen {
> + bootargs = "console=ttyS0,115200";
> + stdout-path = &uart0;
Just here
> + };
[...]
--
Gregory Clement, Free Electrons
Kernel, drivers, real-time and embedded Linux
development, consulting, training and support.
http://free-electrons.com
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
