Hi Krzysztof, On Sat, May 16, 2015 at 08:53:42PM +0900, Krzysztof Kozlowski wrote: > 2015-05-15 23:06 GMT+09:00 Laurentiu Palcu <laurentiu.palcu@xxxxxxxxx>: > > Signed-off-by: Laurentiu Palcu <laurentiu.palcu@xxxxxxxxx> > > --- > > .../devicetree/bindings/power/bq25890.txt | 45 ++++++++++++++++++++++ > > 1 file changed, 45 insertions(+) > > create mode 100644 Documentation/devicetree/bindings/power/bq25890.txt > > > > diff --git a/Documentation/devicetree/bindings/power/bq25890.txt b/Documentation/devicetree/bindings/power/bq25890.txt > > new file mode 100644 > > index 0000000..44f50a7 > > --- /dev/null > > +++ b/Documentation/devicetree/bindings/power/bq25890.txt > > @@ -0,0 +1,45 @@ > > +Binding for TI bq25890 Li-Ion Charger > > + > > +Required properties: > > +- compatible: Should contain one of the following: > > + * "ti,bq25890" > > +- reg: integer, i2c address of the device. > > +- ti,battery-regulation-voltage: integer, maximum charging voltage (in uV); > > +- ti,charge-current: integer, maximum charging current (in uA); > > +- ti,termination-current: integer, charge will be terminated when current in > > + constant-voltage phase drops below this value (in uA); > > +- ti,precharge-current: integer, maximum charge current during precharge > > + phase (in uA); > > +- ti,minimum-sys-voltage: integer, when battery is charging and it is below > > + minimum system voltage, the system will be regulated above > > + minimum-sys-voltage setting (in uV); > > +- ti,boost-voltage: integer, VBUS voltage level in boost mode (in uV); > > +- ti,boost-max-current: integer, maximum allowed current draw in boost mode > > + (in uA). > > + > > +Optional properties: > > +- ti,boost-low-freq: boolean, if present boost mode frequency will be 500kHz, > > + otherwise 1.5MHz; > > +- ti,use-ilim-pin: boolean, if present the ILIM resistor will be used and the > > + input current will be the lower between the resistor setting and the IINLIM > > + register setting; > > +- ti,thermal-regulation-threshold: integer, temperature above which the charge > > + current is lowered, to avoid overheating (in degrees Celsius); > > What if property is absent? The temperature will be ignored? If so, > maybe consider adding such short statement about the default state? You're right, I should've mentioned it here. If it's missing, the default value will be used (120 degrees Celsius). I'll add a comment about it in v2. Thanks for reviewing, laurentiu -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
