Am 13.05.2015 um 13:00 schrieb Linus Walleij:
> On Tue, May 12, 2015 at 6:25 PM, Oleksij Rempel <linux@xxxxxxxxxxxxxxxx> wrote:
>> Am 05.05.2015 um 17:12 schrieb Linus Walleij:
>
>>> Just reference the statically defined array by a pointer instead,
>>> this just takes up a lot o memory for no reason.
>>
>> This two arrays have different types this is why i convert it.
>> priv->pin_desc[i].name - here i copy pointer any ways, and
>> priv->pin_desc[i].number can be smaller then pointer.
>
> I probably do not understand what you're trying to do, sorry :(
>
> Why is it necessary for the driver to copy one description of
> the pin into another?
>
>>> Mory copying. I don't see why this is necessary at all.
>>
>> I hadn't seen the point to define groups statically, especially because
>> they are used only to make curious user happy. So, memory will be used
>> only if you request the list over sysfs. Or miss some thing?
>
> pinctrl does not even use sysfs.
>
> The group names are usually there for matching with a function,
> it is part of the core functionality. The group name + function name
> matching is even more obvious in the dt case.
>
> They also make things easier to read in debugfs yes, but
> the core of the crux is to make it easy to config function+groups
> states with e.g. DT or board files.
>
>>>> +static struct pinmux_ops asm9260_pinmux_ops = {
>>>> + .get_functions_count = asm9260_pinctrl_get_funcs_count,
>>>> + .get_function_name = asm9260_pinctrl_get_func_name,
>>>> + .get_function_groups = asm9260_pinctrl_get_func_groups,
>>>> + .set_mux = asm9260_pinctrl_set_mux,
>>>> + /* TODO: should we care about gpios here? gpio_request_enable? */
>>>
>>> I think you should, if you also have a matching GPIO driver.
>>
>> I fear it would cause unpredictable bugs. GPIO mode is just one of mux
>> modes. If some one will request gpio some busy or dangerous line it
>> would do more harm then use. So, i assume limiting this only to device
>> tree would be better.
>
> Device tree or not doesn't matter, .gpio_request_enable() is used
> as a shortcut to mux in GPIO pins.
>
> If the simultaneous use of a pin for a device and GPIO bothers
> you there is nowadays (linux-next or my devel branch) a .strict
> option in pinmux_ops that you can set to disallow simultaneous
> use by devices and GPIO of the same pin.
>
> Yours,
> Linus Walleij
>
Hi, you was right, i was blind. Will redo some parts with your suggestions.
--
Regards,
Oleksij
Attachment:
signature.asc
Description: OpenPGP digital signature
