On 15/03/2025 01:49, Amit Sunil Dhamne wrote: > Hi Krzysztof, > > Thanks for the review! > > On 3/13/25 1:50 AM, Krzysztof Kozlowski wrote: >> On Wed, Mar 12, 2025 at 04:42:00PM -0700, Amit Sunil Dhamne wrote: >>> Support for Battery Status & Battery Caps messages in response to >>> Get_Battery_Status & Get_Battery_Cap request is required by USB PD devices >>> powered by battery, as per "USB PD R3.1 V1.8 Spec", "6.13 Message >>> Applicability" section. This patchset adds support for these AMSes >>> to achieve greater compliance with the spec. >> Which board uses it? I would be happy to see that connection between >> batteries and USB connector on the schematics of some real device. How >> does it look like? > Any board that uses a USB Type-C connector that supplies power into or If you keep responding like this, you will got nowhere, so let me re-iterate: Which upstream DTS (or upstream supported hardware) is going to use this binding, so I can see how you are going to implement it there in the entire system? > out of a battery while operating in sink or source mode respectively. > The VBUS is connected to the (battery + buck boost IC's CHGin/Vin) or a > companion IFPMIC connected to a battery. In our board we have USB > Connector <-> IFPMIC <-> Battery. Which board is that? Best regards, Krzysztof
