Hi Russell,
On Tue, 4 Mar 2025 at 11:00, Russell King (Oracle)
<linux@xxxxxxxxxxxxxxx> wrote:
> For the failure to happen, you need to check whether EEE is being used:
>
> # ethtool --show-eee ethX
Doh, that's also not supported on Starlight (BeagleV beta).
I tried unbind/rebind regardless, and it works (sort of),
using the old Beagle V Fedora rootfs on microSD:
[root@fedora-starfive starfive-dwmac]# echo 10020000.ethernet > unbind
starfive-dwmac 10020000.ethernet eth0: stmmac_dvr_remove: removing driver
starfive-dwmac 10020000.ethernet eth0: Link is Down
[root@fedora-starfive starfive-dwmac]# echo 10020000.ethernet > bind
starfive-dwmac 10020000.ethernet: IRQ eth_lpi not found
starfive-dwmac 10020000.ethernet: IRQ sfty not found
starfive-dwmac 10020000.ethernet: Hash table entries set to unexpected value 32
starfive-dwmac 10020000.ethernet: User ID: 0x59, Synopsys ID: 0x37
starfive-dwmac 10020000.ethernet: DWMAC1000
starfive-dwmac 10020000.ethernet: DMA HW capability register supported
starfive-dwmac 10020000.ethernet: RX Checksum Offload Engine supported
starfive-dwmac 10020000.ethernet: COE Type 2
starfive-dwmac 10020000.ethernet: Wake-Up On Lan supported
starfive-dwmac 10020000.ethernet: Enhanced/Alternate descriptors
starfive-dwmac 10020000.ethernet: Enabled extended descriptors
starfive-dwmac 10020000.ethernet: Chain mode enabled
starfive-dwmac 10020000.ethernet: Enable RX Mitigation via HW Watchdog Timer
starfive-dwmac 10020000.ethernet: device MAC address fa:58:39:0a:37:37
libphy: get_phy_c22_id: mii_bus stmmac phy_id = 0x00221622
starfive-dwmac 10020000.ethernet eth0: Register MEM_TYPE_PAGE_POOL RxQ-0
starfive-dwmac 10020000.ethernet eth0: PHY [stmmac-0:07] driver
[Micrel KSZ9031 Gigabit PHY] (irq=POLL)
dwmac1000: Master AXI performs fixed burst length
starfive-dwmac 10020000.ethernet eth0: No Safety Features support found
starfive-dwmac 10020000.ethernet eth0: No MAC Management Counters available
starfive-dwmac 10020000.ethernet eth0: IEEE 1588-2008 Advanced
Timestamp supported
starfive-dwmac 10020000.ethernet eth0: configuring for phy/rgmii-id link mode
starfive-dwmac 10020000.ethernet eth0: Link is Up - 1Gbps/Full - flow
control off
Apparently the MAC address has changed, so the board got a different
IP address from my DHCP server :-(
Gr{oetje,eeting}s,
Geert
--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@xxxxxxxxxxxxxx
In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds
