Hi Conor, Hi Sakari, On Fri, Feb 28, 2025 at 07:11:31PM +0000, Conor Dooley wrote: > On Thu, Feb 27, 2025 at 10:14:02AM +0000, Sakari Ailus wrote: > > Hi Mathis, > > > > On Wed, Feb 26, 2025 at 04:39:23PM +0100, Mathis Foerst wrote: > > > The MT9M114 supports the different slew rates (0 to 7) on the output pads. > > > > "the output pads" probably means pixel data interface (DVP or CSI-2) > > signals in this cases? I suppose this is about clock modulation? > > It'd be good to say that. The slew rate defines the slope of the voltage flanks on the output pads (how fast the pads go from LOW to HIGH or vice versa). I tried to clarify the description. > > > > > At the moment, this is hardcoded to 7 (the fastest rate). > > > The user might want to change this values due to EMC requirements. > > > > > > Add the 'pad-slew-rate' property to the MT9M114 DT-bindings for selecting > > > the desired slew rate. > > > > > > Signed-off-by: Mathis Foerst <mathis.foerst@xxxxxx> > > > --- > > > .../devicetree/bindings/media/i2c/onnn,mt9m114.yaml | 6 ++++++ > > > 1 file changed, 6 insertions(+) > > > > > > diff --git a/Documentation/devicetree/bindings/media/i2c/onnn,mt9m114.yaml b/Documentation/devicetree/bindings/media/i2c/onnn,mt9m114.yaml > > > index 72e258d57186..666afe10c538 100644 > > > --- a/Documentation/devicetree/bindings/media/i2c/onnn,mt9m114.yaml > > > +++ b/Documentation/devicetree/bindings/media/i2c/onnn,mt9m114.yaml > > > @@ -74,6 +74,12 @@ properties: > > > description: Bypass the internal PLL of the sensor to use EXTCLK directly as SYSCLK. > > > type: boolean > > > > > > + onnn,slew-rate: > > > + $ref: /schemas/types.yaml#/definitions/uint8 > > > > No need to make this 8-bit (i.e. just use 32 bits). Okay, I thought 8-bit would fit the small value range [0,7]. Changed it to 32 bits. > > > > > + description: Slew rate ot the output pads DOUT[7:0], LINE_VALID, FRAME_VALID and PIXCLK > > > > Please wrap at 80 characters. > > > > Is there more information on the effect than 7 is the fastest? There is no more information about the exact meaning of the values. As described above, the higher the value, the steeper the voltage flanks. > > > > > + minimum: 0 > > > + maximum: 7 > > > > Please also add a default. Sure, I added the default value 7 that matches the currently hardcoded value in the driver. > > It'd also be great (IMO) if it were given in terms of actual units, not > nebulous values that I assume to be the register values. I agree, but the documentation does not provide further details about the unit of the value. So using the register value is my best-effort approach. > > > > > > + > > > required: > > > - compatible > > > - reg > > > > -- > > Regards, > > > > Sakari Ailus Best regards, Mathis Foerst
