> -----Original Message----- > From: Krzysztof Kozlowski <krzk@xxxxxxxxxx> > Sent: Friday, February 21, 2025 12:47 AM > To: Wilson Ding <dingwei@xxxxxxxxxxx> > Cc: linux-kernel@xxxxxxxxxxxxxxx; devicetree@xxxxxxxxxxxxxxx; linux-arm- > kernel@xxxxxxxxxxxxxxxxxxx; andrew@xxxxxxx; gregory.clement@xxxxxxxxxxx; > sebastian.hesselbarth@xxxxxxxxx; robh@xxxxxxxxxx; krzk+dt@xxxxxxxxxx; > conor+dt@xxxxxxxxxx; p.zabel@xxxxxxxxxxxxxx; Sanghoon Lee > <salee@xxxxxxxxxxx>; Geethasowjanya Akula <gakula@xxxxxxxxxxx> > Subject: [EXTERNAL] Re: [PATCH v2 2/4] dt-bindings: cp110: Document the > reset controller > > On Thu, Feb 20, 2025 at 03: 25: 25PM -0800, Wilson Ding wrote: > Add reset- > controller sub-node into the system controller node, and > document the > supported reset lines. > > Signed-off-by: Wilson Ding > <dingwei@ marvell. com> > > On Thu, Feb 20, 2025 at 03:25:25PM -0800, Wilson Ding wrote: > > Add reset-controller sub-node into the system controller node, and > > document the supported reset lines. > > > > Signed-off-by: Wilson Ding <dingwei@xxxxxxxxxxx> > > --- > > .../arm/marvell/cp110-system-controller.txt | 43 +++++++++++++++++++ > > NAK. > > You already got feedback that TXT bindings are not accepted. > I am not trying to use this TXT for dt-binding. But as you can see this file describes all the sub-nodes details, such as mpps, clocks information. So that I add the reset line info here. If this is not the right place, where shall I put this information. I wonder if you are asking to convert this txt into yaml. > Best regards, > Krzysztof
