On Wed, Feb 12, 2025 at 04:46:20PM +0100, Alexis Lothoré wrote: > WILC3000 is a combo chip providing 802.11b/g/n and Bluetooth 5. The wlan > part is exposed either through SDIO or SPI interface, and the bluetooth > part is exposed through uart. The notable peculiarity of this chip is > that the bluetooth part is not fully autonomous: its firmware is not > loaded through UART interface but through SDIO/SPI interface, so the > bluetooth description needs a reference to the wlan part to get access > to the corresponding bus. > > Signed-off-by: Alexis Lothoré <alexis.lothore@xxxxxxxxxxx> > --- > .../net/bluetooth/microchip,wilc3000-bt.yaml | 41 ++++++++++++++++++++++ > 1 file changed, 41 insertions(+) > > diff --git a/Documentation/devicetree/bindings/net/bluetooth/microchip,wilc3000-bt.yaml b/Documentation/devicetree/bindings/net/bluetooth/microchip,wilc3000-bt.yaml > new file mode 100644 > index 0000000000000000000000000000000000000000..2a83ca3ad90b26fd619b574bc343bee9654a1e43 > --- /dev/null > +++ b/Documentation/devicetree/bindings/net/bluetooth/microchip,wilc3000-bt.yaml > @@ -0,0 +1,41 @@ > +# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause) > +%YAML 1.2 > +--- > +$id: http://devicetree.org/schemas/net/bluetooth/microchip,wilc3000-bt.yaml# > +$schema: http://devicetree.org/meta-schemas/core.yaml# > + > +title: Microchip Bluetooth chips > + > +description: > + This binding describes UART-attached Microchip bluetooth chips. These > + chips are dual-radio chips supporting WiFi and Bluetooth. The bluetooth > + side works with standard HCI commands over 4-wires UART (with flow > + control) > + > +maintainers: > + - Alexis Lothoré <alexis.lothore@xxxxxxxxxxx> > + > +properties: > + compatible: > + enum: > + - microchip,wilc3000-bt > + > + wlan: > + $ref: /schemas/types.yaml#/definitions/phandle > + description: > + Phandle to the wlan part of the combo chip No resources here and judging by the driver everything is part of wifi. Either you wrote it to match driver or indeed hardware is like that. In the first case, why this cannot be part of WiFi with phandle to serial bus? In the second case, this needs to be proper hardware description. Best regards, Krzysztof
