From: Guillaume Stols <gstols@xxxxxxxxxxxx> Since we must access the bus parallel bus using a custom procedure, let's add a specialized compatible, and define specialized callbacks for writing the registers using the parallel interface. Signed-off-by: Guillaume Stols <gstols@xxxxxxxxxxxx> Co-developed-by: Angelo Dureghello <adureghello@xxxxxxxxxxxx> Signed-off-by: Angelo Dureghello <adureghello@xxxxxxxxxxxx> --- drivers/iio/adc/adi-axi-adc.c | 81 +++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 81 insertions(+) diff --git a/drivers/iio/adc/adi-axi-adc.c b/drivers/iio/adc/adi-axi-adc.c index 3e1a997ace76..225ea0497ba9 100644 --- a/drivers/iio/adc/adi-axi-adc.c +++ b/drivers/iio/adc/adi-axi-adc.c @@ -27,6 +27,7 @@ #include <linux/iio/buffer.h> #include <linux/iio/iio.h> +#include "ad7606_bus_iface.h" /* * Register definitions: * https://wiki.analog.com/resources/fpga/docs/axi_adc_ip#register_map @@ -73,6 +74,12 @@ #define ADI_AXI_ADC_REG_DELAY(l) (0x0800 + (l) * 0x4) #define AXI_ADC_DELAY_CTRL_MASK GENMASK(4, 0) +#define ADI_AXI_REG_CONFIG_WR 0x0080 +#define ADI_AXI_REG_CONFIG_RD 0x0084 +#define ADI_AXI_REG_CONFIG_CTRL 0x008c +#define ADI_AXI_REG_CONFIG_CTRL_READ 0x03 +#define ADI_AXI_REG_CONFIG_CTRL_WRITE 0x01 + #define ADI_AXI_ADC_MAX_IO_NUM_LANES 15 #define ADI_AXI_REG_CHAN_CTRL_DEFAULTS \ @@ -80,6 +87,10 @@ ADI_AXI_REG_CHAN_CTRL_FMT_EN | \ ADI_AXI_REG_CHAN_CTRL_ENABLE) +#define ADI_AXI_REG_READ_BIT 0x8000 +#define ADI_AXI_REG_ADDRESS_MASK 0xff00 +#define ADI_AXI_REG_VALUE_MASK 0x00ff + struct axi_adc_info { unsigned int version; const struct iio_backend_info *backend_info; @@ -311,6 +322,75 @@ static struct iio_buffer *axi_adc_request_buffer(struct iio_backend *back, return iio_dmaengine_buffer_setup(st->dev, indio_dev, dma_name); } +static int axi_adc_raw_write(struct iio_backend *back, u32 val) +{ + struct adi_axi_adc_state *st = iio_backend_get_priv(back); + + regmap_write(st->regmap, ADI_AXI_REG_CONFIG_WR, val); + regmap_write(st->regmap, ADI_AXI_REG_CONFIG_CTRL, + ADI_AXI_REG_CONFIG_CTRL_WRITE); + fsleep(100); + regmap_write(st->regmap, ADI_AXI_REG_CONFIG_CTRL, 0x00); + fsleep(100); + + return 0; +} + +static int axi_adc_raw_read(struct iio_backend *back, u32 *val) +{ + struct adi_axi_adc_state *st = iio_backend_get_priv(back); + + regmap_write(st->regmap, ADI_AXI_REG_CONFIG_CTRL, + ADI_AXI_REG_CONFIG_CTRL_READ); + fsleep(100); + regmap_read(st->regmap, ADI_AXI_REG_CONFIG_RD, val); + regmap_write(st->regmap, ADI_AXI_REG_CONFIG_CTRL, 0x00); + fsleep(100); + + return 0; +} + +static int ad7606_bus_reg_read(struct iio_backend *back, u32 reg, u32 *val) +{ + struct adi_axi_adc_state *st = iio_backend_get_priv(back); + int addr; + + guard(mutex)(&st->lock); + + /* + * The address is written on the highest weight byte, and the MSB set + * at 1 indicates a read operation. + */ + addr = FIELD_PREP(ADI_AXI_REG_ADDRESS_MASK, reg) | ADI_AXI_REG_READ_BIT; + axi_adc_raw_write(back, addr); + axi_adc_raw_read(back, val); + + /* Write 0x0 on the bus to get back to ADC mode */ + axi_adc_raw_write(back, 0); + + return 0; +} + +static int ad7606_bus_reg_write(struct iio_backend *back, u32 reg, u32 val) +{ + struct adi_axi_adc_state *st = iio_backend_get_priv(back); + u32 buf; + + guard(mutex)(&st->lock); + + /* Write any register to switch to register mode */ + axi_adc_raw_write(back, 0xaf00); + + buf = FIELD_PREP(ADI_AXI_REG_ADDRESS_MASK, reg) | + FIELD_PREP(ADI_AXI_REG_VALUE_MASK, val); + axi_adc_raw_write(back, buf); + + /* Write 0x0 on the bus to get back to ADC mode */ + axi_adc_raw_write(back, 0); + + return 0; +} + static void axi_adc_free_buffer(struct iio_backend *back, struct iio_buffer *buffer) { @@ -498,6 +578,7 @@ static const struct axi_adc_info adc_ad7606 = { /* Match table for of_platform binding */ static const struct of_device_id adi_axi_adc_of_match[] = { { .compatible = "adi,axi-adc-10.0.a", .data = &adc_generic }, + { .compatible = "adi,axi-ad7606x", .data = &adc_ad7606 }, { /* end of list */ } }; MODULE_DEVICE_TABLE(of, adi_axi_adc_of_match); -- 2.47.0
