Am Montag, 10. Februar 2025, 03:36:48 CET schrieb Peng Fan: > ******************** > Achtung externe E-Mail: Öffnen Sie Anhänge und Links nur, wenn Sie wissen, dass diese aus einer sicheren Quelle stammen und sicher sind. Leiten Sie die E-Mail im Zweifelsfall zur Prüfung an den IT-Helpdesk weiter. > Attention external email: Open attachments and links only if you know that they are from a secure source and are safe. In doubt forward the email to the IT-Helpdesk to check it. > ******************** > > > Subject: Re: [PATCH v2 04/10] arm64: dts: imx8mn: Add access- > > controller references > > > > Hi Peng, > > > > Am Freitag, 7. Februar 2025, 13:02:13 CET schrieb Peng Fan: > > > On Fri, Feb 07, 2025 at 09:36:09AM +0100, Alexander Stein wrote: > > > >Mark ocotp as a access-controller and add references on peripherals > > > >which can be disabled (fused). > > > > > > I am not sure whether gpcv2 changes should be included in this > > > patchset or not. Just add access-controller for fused IP will not work. > > > > Well, I was able to successfully boot a i.MX8M Nano DualLite. > > > > > i.MX8M BLK-CTRL/GPC will hang if the related power domain is still > > > touched by kernel. The pgc can't power up/down because clock is > > gated. > > > > Well, with GPU node disabled, no one should enable the power domain. > > But to be on the safe side I would also add access-controllers to the > > corresponding power domains as well. > > > > > This comment also apply to i.MX8MM/P. > > > > Sure. Do you have any information what is actually disabled by those > > fused? > > It seems it's the IP and their power domains. Anything else? > > In NXP downstream there is a patch for drivers/pmdomain/imx/imx8m-blk-ctrl.c > > soc: imx8m-blk-ctrl: Support fused modules > > For fused module, its pgc can't power up/down and clock is gated. > Because imx8m-blk-ctrl driver will pm_runtime_get_sync/pm_runtime_put > all power domains during suspend/resume. So we have to remove the > pgc and clock of fused module from blk-ctrl DTS node. > Update the driver to support such case. > > But this patch also needs U-Boot to update device tree nodes, > I recalled that U-Boot will remove gpc nodes, but not update blk-ctrl nodes. Does it work, if we add the access-controller as well for pgc_gpu3d on imx8mp? There is nothing in blk-ctrl AFAICS. But for VPU there is. Which clock needs to be removed there in case g1 is disabled? Best regards, Alexander -- TQ-Systems GmbH | Mühlstraße 2, Gut Delling | 82229 Seefeld, Germany Amtsgericht München, HRB 105018 Geschäftsführer: Detlef Schneider, Rüdiger Stahl, Stefan Schneider http://www.tq-group.com/