Looking at the board file for WG302 v2 was not a good idea
because the GPIO IRQ for slot 2 differs, and v1 uses GPIO
10 instead of GPIO 9. Fix it up.
Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
---
arch/arm/boot/dts/intel/ixp/intel-ixp42x-netgear-wg302v1.dts | 10 +++++-----
1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/arch/arm/boot/dts/intel/ixp/intel-ixp42x-netgear-wg302v1.dts b/arch/arm/boot/dts/intel/ixp/intel-ixp42x-netgear-wg302v1.dts
index 19d56e9aec9d89ce0ad109fbc6bb6e26327997f9..af7b6a976d3dd61f3c6846c73b8788437dea20e3 100644
--- a/arch/arm/boot/dts/intel/ixp/intel-ixp42x-netgear-wg302v1.dts
+++ b/arch/arm/boot/dts/intel/ixp/intel-ixp42x-netgear-wg302v1.dts
@@ -57,7 +57,7 @@ pci@c0000000 {
status = "okay";
/*
- * Taken from WG302 v2 PCI boardfile (wg302v2-pci.c)
+ * Taken from WG302 v1 PCI boardfile (wg302v1-pci.c)
* We have slots (IDSEL) 1 and 2 with one assigned IRQ
* each handling all IRQs.
*/
@@ -70,10 +70,10 @@ pci@c0000000 {
<0x0800 0 0 3 &gpio0 8 IRQ_TYPE_LEVEL_LOW>, /* INT C on slot 1 is irq 8 */
<0x0800 0 0 4 &gpio0 8 IRQ_TYPE_LEVEL_LOW>, /* INT D on slot 1 is irq 8 */
/* IDSEL 2 */
- <0x1000 0 0 1 &gpio0 9 IRQ_TYPE_LEVEL_LOW>, /* INT A on slot 2 is irq 9 */
- <0x1000 0 0 2 &gpio0 9 IRQ_TYPE_LEVEL_LOW>, /* INT B on slot 2 is irq 9 */
- <0x1000 0 0 3 &gpio0 9 IRQ_TYPE_LEVEL_LOW>, /* INT C on slot 2 is irq 9 */
- <0x1000 0 0 4 &gpio0 9 IRQ_TYPE_LEVEL_LOW>; /* INT D on slot 2 is irq 9 */
+ <0x1000 0 0 1 &gpio0 10 IRQ_TYPE_LEVEL_LOW>, /* INT A on slot 2 is irq 10 */
+ <0x1000 0 0 2 &gpio0 10 IRQ_TYPE_LEVEL_LOW>, /* INT B on slot 2 is irq 10 */
+ <0x1000 0 0 3 &gpio0 10 IRQ_TYPE_LEVEL_LOW>, /* INT C on slot 2 is irq 10 */
+ <0x1000 0 0 4 &gpio0 10 IRQ_TYPE_LEVEL_LOW>; /* INT D on slot 2 is irq 10 */
};
ethernet@c8009000 {
--
2.48.1
