On 2/6/25 4:00 AM, Miclaus, Antoniu wrote:
>> On 1/27/25 4:57 AM, Antoniu Miclaus wrote:
>>> Add support for the AD485X a fully buffered, 8-channel simultaneous
>>> sampling, 16/20-bit, 1 MSPS data acquisition system (DAS) with
>>> differential, wide common-mode range inputs.
>>>
>>> Signed-off-by: Antoniu Miclaus <antoniu.miclaus@xxxxxxxxxx>
>>> ---
>>
>> I think we have the important bits sorted now (i.e. userspace-facing stuff).
>> Just noticed a few minor things in the latest revision.
>>
>>
>>> +static int ad4851_setup(struct ad4851_state *st)
>>> +{
>>> + unsigned int product_id;
>>> + int ret;
>>> +
>>> + if (st->pd_gpio) {
>>> + /* To initiate a global reset, bring the PD pin high twice */
>>> + gpiod_set_value(st->pd_gpio, 1);
>>> + fsleep(1);
>>> + gpiod_set_value(st->pd_gpio, 0);
>>> + fsleep(1);
>>> + gpiod_set_value(st->pd_gpio, 1);
>>> + fsleep(1);
>>> + gpiod_set_value(st->pd_gpio, 0);
>>> + fsleep(1000);
>>> + } else {
>>> + ret = regmap_set_bits(st->regmap,
>> AD4851_REG_INTERFACE_CONFIG_A,
>>> + AD4851_SW_RESET);
>>> + if (ret)
>>> + return ret;
>>
>> Do we also need fsleep() after software reset?
> The datasheet doesn't mention any delay required after performing Software Reset.
> Should I add something just as a safety measure?
I guess it is probably OK if the datasheet doesn't say it needs a delay.
